If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
My first big IFR mistake...
I made my first big IFR mistake. I fixed my intermittant ADF with only
a few more hours of training to go until my checkride. My glorious plan to label it INOP (making it an expensive combination multi-channel timer and partial panel heading memory aid) has been thwarted by a little tuner cleaner on the card edge connector and the socket on the tray. A small part of me was hoping that the aluminum swarf that someone rained down on it while modifying the panel (which I removed a while ago without fully fixing the problem) had killed it for good. Anyone have any good NDB approach tips and tricks? -- Ben Jackson http://www.ben.com/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Correcting Poly-Brush mistake | Craig Foster | Home Built | 31 | November 23rd 03 01:55 PM |