If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Richard Kaplan wrote: Actually, I do not have a KNS-80 or other VOR/DME RNAV system in my simulator; the KNS-80 is in my airplane. I agree with you there is no point in a brand-new KNS-80 installation either in an airplane or in a simulator. I am, however, debating in my mind whether to install a Garmin 430 vs. 530 later this year as part of an avionics upgrade, and I am leaning toward the 430 because it would save enough space to allow me to keep the KNS-80 and thus maintain true DME and VOR/DME RNAV capability, two forms of navigation which the Garmin 430/530 can only emulate based on GPS calculations. The errors that the KNS-80 are subjected to are unquantifible at this point. If the FAA were honest about it all, they would decertify the set for en route operations. Having used both the 530 and 430 I like the 530 a whole lot better. The big display, and two separate map pages make it the clear choice if you can afford it. Having said that, a 530 and a 430 make a great installation, too. You end up with redundancy everywhere and use the 530 as your primary RNAV set. Everything about the 530 is easier, including being able to see many more legs or flight plans on FP pages 1 and 2. |
#12
|
|||
|
|||
wrote in message ... The errors that the KNS-80 are subjected to are unquantifible at this point. If the FAA were honest about it all, they would decertify the set for en route operations. Is this any worse than NDBs which have been used for quite some time? Everything about the 530 is easier, including being able to see many more legs or flight plans on FP pages 1 and 2. Easier? Yes. Is there any more function or accuracy in a 530 than a 430? No. Having used both the 530 and 430 I like the 530 a whole lot better. The big display, and two separate map pages make it the clear choice if you can afford it. Having said that, a 530 and a 430 make a great installation, too. You end Cost is not the only issue -- panel space is an issue. That saves panel space for other avionics. Even better is crossfeeding a 530 or 430 to a handhdle 195 or 196 or 295. A 430 crossfed to a Garmin handheld GPS is one of the best kept secrets of avionics value... a 430 / 195 combination gives at least as much useful information as a 530 at a dramatically reduced cost. It is actually better than a 430/430 combination or 530/430 combination because (a) the handheld Garmins provide an electronic HSI; and (b) the handheld Garmins serve as an electrical backup. With crossfeed from the panel GPS to the handheld GPS, a pilot would not even skip a beat transitioning to the portable GPS in the event of a sudden complete electrical failure in IMC. -- Richard Kaplan, CFII www.flyimc.com |
#13
|
|||
|
|||
Richard, today 9 MAR 2004 you wrote:
...................... Even better is crossfeeding a 530 or 430 to a handhdle 195 or 196 or 295. A 430 crossfed to a Garmin handheld GPS is one of the best kept secrets of avionics value... a 430 / 195 combination gives at least as much useful information as a 530 at a dramatically reduced cost. It is actually better than a 430/430 combination or 530/430 combination because (a) the handheld Garmins provide an electronic HSI; and (b) the handheld Garmins serve as an electrical backup. With crossfeed from the panel GPS to the handheld GPS, a pilot would not even skip a beat transitioning to the portable GPS in the event of a sudden complete electrical failure in IMC. -- Richard Kaplan, CFII www.flyimc.com Could you reveal that secret of crossfeeding a 430 to a Garmin Handheld GPS please? I had just as backup and for user waypoint management a Garmin 196 installed at the yoke of a 172 and would like to learn about that interesting crossfeeding. The 196 Pilot's Guide at page 96 under INTERFACE just holds a rather brief statement on the topic: Aviation In - the proprietary format used for connection to a Garmin panel-mounted GPS receiver. Allows Goto or route selection on the panel mounted GPS receiver to be automatically displayed on the GPSMAP 196. This eliminates the need to enter the destination to both units. And at page 100 under INTERFACING: ... The following formats are supported for connection of external devices: ... Garmin proprietary aviation input, ... . You can download a copy of Garmin's proprietary communication protocoll from the Help and Support section of our website at www.garmin.com Guess, it needs some tinkering of the avionic experts to make such connection work? Otto (EDML) |
#14
|
|||
|
|||
The 530 has an "arc view" map page that the 430 does not. I find it to be
the most useful moving map page and use it all the time. Mike MU-2 "Richard Kaplan" wrote in message s.com... wrote in message ... The errors that the KNS-80 are subjected to are unquantifible at this point. If the FAA were honest about it all, they would decertify the set for en route operations. Is this any worse than NDBs which have been used for quite some time? Everything about the 530 is easier, including being able to see many more legs or flight plans on FP pages 1 and 2. Easier? Yes. Is there any more function or accuracy in a 530 than a 430? No. Having used both the 530 and 430 I like the 530 a whole lot better. The big display, and two separate map pages make it the clear choice if you can afford it. Having said that, a 530 and a 430 make a great installation, too. You end Cost is not the only issue -- panel space is an issue. That saves panel space for other avionics. Even better is crossfeeding a 530 or 430 to a handhdle 195 or 196 or 295. A 430 crossfed to a Garmin handheld GPS is one of the best kept secrets of avionics value... a 430 / 195 combination gives at least as much useful information as a 530 at a dramatically reduced cost. It is actually better than a 430/430 combination or 530/430 combination because (a) the handheld Garmins provide an electronic HSI; and (b) the handheld Garmins serve as an electrical backup. With crossfeed from the panel GPS to the handheld GPS, a pilot would not even skip a beat transitioning to the portable GPS in the event of a sudden complete electrical failure in IMC. -- Richard Kaplan, CFII www.flyimc.com |
#15
|
|||
|
|||
Glad you said that, Mike. I feel the same way.
I always keep the arc view on my CNX80 for navigation, while (mostly) showing the "North-Up" map on my MX20 for situational awareness. ---JRC--- "Mike Rapoport" wrote in message = ink.net... The 530 has an "arc view" map page that the 430 does not. I find it = to be the most useful moving map page and use it all the time. =20 Mike MU-2 |
#16
|
|||
|
|||
In article m, "Richard
Kaplan" writes: Even better is crossfeeding a 530 or 430 to a handhdle 195 or 196 or 295. A 430 crossfed to a Garmin handheld GPS is one of the best kept secrets of avionics value... a 430 / 195 combination gives at least as much useful information as a 530 at a dramatically reduced cost. Very interesting, Richard! Tell me more (like how to do) as I have a 430 on the panel and a 195 on the yoke and they are not sharing info. Do I need to go to the avionics shop and get the connection to the 430? I don't remember any front panel controls and I don't like going to the back. How do I tap into the 195 connector? I use ships power to the 195 (with battery backup). TIA Chuck |
#17
|
|||
|
|||
"Otto Braasch" wrote in message
... Could you reveal that secret of crossfeeding a 430 to a Garmin Handheld GPS please? The details are in the Garmin 430/530 installation guide, which I can email you directly if you wish as it is no longer available on the Garmin site. You need to have your avionics shop do this (they certainly have the installation guide); it is not particularly difficult. -- Richard Kaplan, CFII www.flyimc.com |
#18
|
|||
|
|||
"Mike Rapoport" wrote in message ink.net... The 530 has an "arc view" map page that the 430 does not. I find it to be the most useful moving map page and use it all the time. As I said, the 530 is easier to use but does not contain any functionality that the 430 does not, i.e. there is no approach or other IFR function the 530 does that the 430 cannot do. Sort of like the difference between an HSI vs. a DG and CDI... the HSI is easier to use but does not give any additional functionality. -- Richard Kaplan, CFII www.flyimc.com |
#19
|
|||
|
|||
"PaulaJay1" wrote in message
... Very interesting, Richard! Tell me more (like how to do) as I have a 430 on the panel and a 195 on the yoke and they are not sharing info. Do I need to go to the avionics shop and Yes, it has to be connected by the avionics shop but it is a simple project and well worth the effort. -- Richard Kaplan, CFII www.flyimc.com |
#20
|
|||
|
|||
Richard Kaplan wrote:
The details are in the Garmin 430/530 installation guide, which I can email you directly if you wish as it is no longer available on the Garmin site. You need to have your avionics shop do this (they certainly have the installation guide); it is not particularly difficult. Thanks Richard - I will visit the shop tomorrow and have them check on the manual. Otto Braasch [EDML] |
Thread Tools | |
Display Modes | |
|
|