If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#101
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
The Horny Goat writes:
On Fri, 09 May 2008 18:22:55 -0400, "Dean A. Markley" wrote: Well Ed, I was half expecting a blonde babe from the posting title. I kind of like thinking about Elin Nordegen too but what she has to do with military or naval matters is beyond me. (Anyone who doesn't know who she is can Google) Elin Nordegren... I could get a woody just thinking about her. Only problem is then I associate woody with woods, and that's about all I can take... I break down in tears :-) Tiger has done exceptionally well for himself! -- BOFH excuse #113: Root nameservers are out of sync |
#102
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
Gernot Hassenpflug wrote:
Elin Nordegren... I could get a woody just thinking about her. Only problem is then I associate woody with woods, and that's about all I can take... I break down in tears :-) Tiger has done exceptionally well for himself! insert golf joke here - how many strokes on that hole, etc I would try a #3 wood and sink the putt in about 30 (while thinking about cricket scores, football, my childhood piano teacher etc) -- Cheers Dave Kearton (30 seconds, that is ;-( |
#103
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
Dave Kearton wrote:
Gernot Hassenpflug wrote: Elin Nordegren... I could get a woody just thinking about her. Only problem is then I associate woody with woods, and that's about all I can take... I break down in tears :-) Tiger has done exceptionally well for himself! insert golf joke here - how many strokes on that hole, etc I would try a #3 wood and sink the putt in about 30 (while thinking about cricket scores, football, my childhood piano teacher etc) If the make the woods out of metal now are they still called woods? Dan, U.S. Air Force, retired |
#104
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
Dan wrote:
Dave Kearton wrote: Gernot Hassenpflug wrote: Elin Nordegren... I could get a woody just thinking about her. Only problem is then I associate woody with woods, and that's about all I can take... I break down in tears :-) Tiger has done exceptionally well for himself! insert golf joke here - how many strokes on that hole, etc I would try a #3 wood and sink the putt in about 30 (while thinking about cricket scores, football, my childhood piano teacher etc) If the make the woods out of metal now are they still called woods? Dan, U.S. Air Force, retired ....because most retirees can't say "titaniums" -- Cheers Dave Kearton |
#105
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
On May 15, 11:40 am, "JR Weiss"
wrote: "Douglas Eagleson" wrote: http://www.aoe.vt.edu/~mason/Mason_f...AlphaNotes.pdf Here is a study that mentions a critical aspect of the issue of canard flight. High angle of attack allows for very fast roll rates in general. A wing designed for high angle of attack becomes a superior wing in general. Where does it say that? What was the max roll rate of the Wright Flyer? AJ-37 Viggen? A-4E Skyhawk? F-5E Tiger? SNIP a ton: The two fastest 'rollers' Iknow of are the F104 Starfighter and the F5 series. The 104 clocks out at about 420 degrees per second - note the Flight Manual limitation is 360 degrees of roll - if below 1/2 G, 180 degrees. This is to stay out of inertial coupling, which is a really good idea.. The F5 series is credited with 450 degrees per second. I have never flown a T38 or an F5. so can't speak to that. However, I have done maximum rate rolls in a 104A. This requires the pilot to grab the canopy rail with his free hand to brace himself against the lateral acceleration. Otherwise he will be slammed sideways in the seat and inadvertently take out some aileron. Additionally, if he desires to roll out at any given bank angle he has to start recovery with about 45 degrees to go. The 'book' says 90, but that's for non-acrobatic/ACM-current pilots. It is difficult to see the value of higher rates of roll; it's hard enough at 420 degrees per second to monitor what's going on outside the airplane. But that rate of onset/recovery sure does make for snappy pointed (hesitation) rolls and counters scissors by dissimilar aircraf very nicely. Hmm. something new - an anti-bot countermeasure! Walt BJ |
#106
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
On Mon, 26 May 2008 19:37:55 -0700 (PDT), WaltBJ
wrote: SNIP a ton: The two fastest 'rollers' Iknow of are the F104 Starfighter and the F5 series. The 104 clocks out at about 420 degrees per second - note the Flight Manual limitation is 360 degrees of roll - if below 1/2 G, 180 degrees. This is to stay out of inertial coupling, which is a really good idea.. The F5 series is credited with 450 degrees per second. I have never flown a T38 or an F5. so can't speak to that. I logged time in the T-38 in pilot training and flying some FCF profiles afterward during my years as a UPT instructor, then four years doing instructor training in Fighter Lead-In flying the AT-38B. The T-38 roll-rate is listed at 720 degrees per second. The stick throw is 6" either side of center, with the first 4.5" giving you 50% of aileron deflection and the last 1.5" giving you the full deflection for max rate rolls. Dash-1 restriction is against continuous full deflection rolls with a warning that it is difficult to stop full deflection in less than two rolls. The FCF profile involves rolls left and right with first half-rate and then a full-deflection in each direction. It will make your head spin and if you are not braced, bounce your helmet off the canopy. It has virtually NO tactical utility. Ed Rasimus Fighter Pilot (USAF-Ret) "When Thunder Rolled" "Palace Cobra" www.thunderchief.org |
#107
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
On May 27, 6:18*am, Ed Rasimus wrote:
On Mon, 26 May 2008 19:37:55 -0700 (PDT), WaltBJ wrote: SNIP a ton: * The two fastest 'rollers' Iknow of are the F104 Starfighter and the F5 series. The 104 clocks out at about 420 degrees per second - note the Flight Manual limitation is 360 degrees of roll - if below 1/2 G, 180 degrees. This is to stay out of inertial coupling, which is a really good idea.. The F5 series is credited with 450 degrees per second. I have never flown a T38 or an F5. so can't speak to that. I logged time in the T-38 in pilot training and flying some FCF profiles afterward during my years as a UPT instructor, then four years doing instructor training in Fighter Lead-In flying the AT-38B. The T-38 roll-rate is listed at 720 degrees per second. The stick throw is 6" either side of center, with the first 4.5" giving you 50% of aileron deflection and the last 1.5" giving you the full deflection for max rate rolls. Dash-1 restriction is against continuous full deflection rolls with a warning that it is difficult to stop full deflection in less than two rolls. The FCF profile involves rolls left and right with first half-rate and then a full-deflection in each direction. It will make your head spin and if you are not braced, bounce your helmet off the canopy. It has virtually NO tactical utility. Ed Rasimus Fighter Pilot (USAF-Ret) "When Thunder Rolled" "Palace Cobra"www.thunderchief.org A spiral or corkscrew as a maneuver allows an escape. You need elevator deflection, while entering the simple aileron roll, as a rule to cause the high angle of attack necessary to slow the aircraft and corkscrew breakoff to the anywhere direction. High angle of attack roll rate is critical to either following the target or breaking off. Matching the target is advised and it is as follows. 1. elevator deflect and roll positive g. 2. As 180 degree roll is passed a person needs to do a single elevator motion. And if you get it wrong the maneuver turns into a dive. 3. SO push on the elevator to mAKE THE FORWARD CORCKSCREW POSSIBLE. So it is a hard thing to get the hang of and it has negative gs. A special modification was to aerodynamics. What can be changed. A dive as arule is always sort of expected. SO a vertical exit from the corkscrew appear the false exit. A fake exit is possible aerodynamically. A simple vertical followed by a return to the corkscrew really making it impossible to follow. ALWAYS lossing the trailing aircraft. |
#108
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
"Douglas Eagleson" wrote in message ... On May 27, 6:18 am, Ed Rasimus wrote: On Mon, 26 May 2008 19:37:55 -0700 (PDT), WaltBJ The T-38 roll-rate is listed at 720 degrees per second. The stick throw is 6" either side of center, with the first 4.5" giving you 50% of aileron deflection and the last 1.5" giving you the full deflection for max rate rolls. Dash-1 restriction is against continuous full deflection rolls with a warning that it is difficult to stop full deflection in less than two rolls. The FCF profile involves rolls left and right with first half-rate and then a full-deflection in each direction. It will make your head spin and if you are not braced, bounce your helmet off the canopy. It has virtually NO tactical utility. Ed Rasimus Fighter Pilot (USAF-Ret) "When Thunder Rolled" "Palace Cobra"www.thunderchief.org A spiral or corkscrew as a maneuver allows an escape. You need elevator deflection, while entering the simple aileron roll, as a rule to cause the high angle of attack necessary to slow the aircraft and corkscrew breakoff to the anywhere direction. Oh great a janitor advising a fighter pilot on air combat tactics Sheesh Keith |
#109
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
On May 27, 10:53 am, Douglas Eagleson
wrote: On May 27, 6:18 am, Ed Rasimus wrote: On Mon, 26 May 2008 19:37:55 -0700 (PDT), WaltBJ wrote: SNIP a ton: The two fastest 'rollers' Iknow of are the F104 Starfighter and the F5 series. The 104 clocks out at about 420 degrees per second - note the Flight Manual limitation is 360 degrees of roll - if below 1/2 G, 180 degrees. This is to stay out of inertial coupling, which is a really good idea.. The F5 series is credited with 450 degrees per second. I have never flown a T38 or an F5. so can't speak to that. I logged time in the T-38 in pilot training and flying some FCF profiles afterward during my years as a UPT instructor, then four years doing instructor training in Fighter Lead-In flying the AT-38B. The T-38 roll-rate is listed at 720 degrees per second. The stick throw is 6" either side of center, with the first 4.5" giving you 50% of aileron deflection and the last 1.5" giving you the full deflection for max rate rolls. Dash-1 restriction is against continuous full deflection rolls with a warning that it is difficult to stop full deflection in less than two rolls. The FCF profile involves rolls left and right with first half-rate and then a full-deflection in each direction. It will make your head spin and if you are not braced, bounce your helmet off the canopy. It has virtually NO tactical utility. Ed Rasimus Fighter Pilot (USAF-Ret) "When Thunder Rolled" "Palace Cobra"www.thunderchief.org A spiral or corkscrew as a maneuver allows an escape. You need elevator deflection, while entering the simple aileron roll, as a rule to cause the high angle of attack necessary to slow the aircraft and corkscrew breakoff to the anywhere direction. What? Read what Walt and Ed wrote. Do consider "inertial coupling". If I understand correctly, doing a serious elevator input while speed rolling will "corkscrew" you into the nearest mud. Anyway release wing tip tanks before execution. High angle of attack roll rate is critical to either following the target or breaking off. Matching the target is advised and it is as follows. 1. elevator deflect and roll positive g. 2. As 180 degree roll is passed a person needs to do a single elevator motion. And if you get it wrong the maneuver turns into a dive. 3. SO push on the elevator to mAKE THE FORWARD CORCKSCREW POSSIBLE. So it is a hard thing to get the hang of and it has negative gs. A special modification was to aerodynamics. What can be changed. A dive as arule is always sort of expected. SO a vertical exit from the corkscrew appear the false exit. A fake exit is possible aerodynamically. A simple vertical followed by a return to the corkscrew really making it impossible to follow. ALWAYS lossing the trailing aircraft. WOWser. What trailing aircraft do you have in mind? vs. F104 or F5, perhaps a Mig21? Doug, I'd like to seriously complete your scenario. Regards Ken |
#110
|
|||
|
|||
The Swedish Model: How to build a jet fighter.
Douglas Eagleson wrote:
The FCF profile involves rolls left and right with first half-rate and then a full-deflection in each direction. It will make your head spin and if you are not braced, bounce your helmet off the canopy. Nice to know. It has virtually NO tactical utility. Tell that to the F-86 pilots. Dan |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LETS BUILD A MODEL PLANE | adelsonsl | Aviation Photos | 1 | May 16th 07 11:10 PM |
Swedish! | Owning | 3 | March 3rd 06 12:44 AM | |
The end of the Saab Viggen - The legendary Swedish jet fighter | Iwan Bogels | Simulators | 0 | April 19th 05 07:22 PM |
The Very Last Operational New German Fighter Model Of WW2 | Garrison Hilliard | Military Aviation | 13 | January 13th 04 03:31 PM |
RV Quick Build build times... | [email protected] | Home Built | 2 | December 17th 03 03:29 AM |