|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Aluminum vs Fiberglass landing gear - Pro's and cons.
I'm in the process of building a Team Tango (similar to a Glasair IIFG) and have
a few thoughts about the landing gear. The earlier kits had fiberglass "legs"
and the newer kits have aluminum legs.
I flew in a Tango with the aluminum gear and it seemed quite harsh on landing. I
know aluminum gear doesn't have problems with heat transferred from the brakes
or axle getting things too hot and that the gear can be "gun drilled" to have
they hydraulic lines inside the gear itself with just a small connector hose
from the gear leg to the brake caliper.
Does the aluminum gear have less ability to absorb shock?
Does the fiberglass or aluminum gear take a "set" after awhile setting on a ramp?
Problems with brake lines on fiberglass gear? on aluminum gear.
How do you match the appropriate gear to the airplanes weight?
Can aluminum gear be had in a "aerodynamic" tear drop shape or just a
Any other suggestions would be appreciated. ( pertaining to the gear )
Bart D. Hull
for my Subaru Engine Conversion
for Tango II I'm building.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Aluminum vs Fiberglass landing gear - Pro's and cons.||Bart Hull||Home Built||0||November 24th 03 04:52 AM|
|Aluminum vs Fiberglass landing gear - Pro's and cons.||Bart D. Hull||Home Built||0||November 22nd 03 07:24 AM|