|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 15th 04, 07:20 AM
|
|||
|
|||
AFCAD221
How do I get default fs2004 airports to show in the airport list when I open
afcad221 for the first time. The list I see is very extensive for Europe and the USA but doesn't have the airport for Brisbane International, Australia YBBN or any other Oceania [Australia or NZ region of world] airports. YBBN is a very large airport capable of allowing fully loaded B747s to take off. I have Australian scenery installed in fs2004 and disk 4 in the CD drive. Cheers Peter Cokley 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode