A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Home Built
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

O200 engine



 
 
Thread Tools Display Modes
  #1  
Old August 16th 07, 08:22 AM posted to rec.aviation.homebuilt
Philippe Vessaire
external usenet poster
 
Posts: 49
Default O200 engine

Hello,

I search where is, in the engine, the PN 633309-8 (bearing needle).
I don't found yet in the IPC...

Where may I buy a full overhaul kit, this kit must be send overseas in
Europe.


Thanks
--
Volem rien foutre al païs!
Philippe Vessaire Ò¿Ó¬
  #2  
Old August 16th 07, 03:44 PM posted to rec.aviation.homebuilt
Stealth Pilot[_2_]
external usenet poster
 
Posts: 846
Default O200 engine

On Thu, 16 Aug 2007 09:22:54 +0200, Philippe Vessaire
wrote:

Hello,

I search where is, in the engine, the PN 633309-8 (bearing needle).
I don't found yet in the IPC...

Where may I buy a full overhaul kit, this kit must be send overseas in
Europe.


Thanks


have you munged that part number?
633609-8 is a 'bearing, needle' which the overhaul manual puts as item
-21B on the drawing for that section.
if you flip back a page to figure 3 you'll find it on the item that
inserts on the lower left case half on the drawing.

I've never pulled it apart so I'm not sure what it is.

Stealth Pilot
  #3  
Old August 16th 07, 04:16 PM posted to rec.aviation.homebuilt
Montblack
external usenet poster
 
Posts: 972
Default O200 engine

("Philippe Vessaire")

I'm stealing THIS! Ò¿Ó¬


Paul-Mont :-)


  #4  
Old August 16th 07, 04:21 PM posted to rec.aviation.homebuilt
Philippe Vessaire
external usenet poster
 
Posts: 49
Default O200 engine

Montblack wrote:


I'm stealing THIS! Ò¿Ó¬

you may, it's copyleft

--
Volem rien foutre al païs!
Philippe Vessaire Ò¿Ó¬
  #5  
Old August 16th 07, 04:32 PM posted to rec.aviation.homebuilt
Philippe Vessaire
external usenet poster
 
Posts: 49
Default O200 engine

Stealth Pilot wrote:



I search where is, in the engine, the PN 633309-8 (bearing needle).
I don't found yet in the IPC...


have you munged that part number?
633609-8 is a 'bearing, needle' which the overhaul manual puts as item
-21B on the drawing for that section.
if you flip back a page to figure 3 you'll find it on the item that
inserts on the lower left case half on the drawing.

I've never pulled it apart so I'm not sure what it is.

I think you are right.... but only an item number, no drawing.... It's
why I don't see.

thanks again.
--
Volem rien foutre al païs!
Philippe Vessaire Ò¿Ó¬
  #6  
Old August 16th 07, 06:00 PM posted to rec.aviation.homebuilt
Montblack
external usenet poster
 
Posts: 972
Default O200 engine

("Philippe Vessaire" wrote)
I'm stealing THIS! Ò¿Ó¬


you may, it's copyleft



Well all right then.


Paul-Mont Ò¿Ó¬


  #7  
Old August 17th 07, 01:08 PM posted to rec.aviation.homebuilt
Stealth Pilot[_2_]
external usenet poster
 
Posts: 846
Default O200 engine

On Thu, 16 Aug 2007 17:32:41 +0200, Philippe Vessaire
wrote:

Stealth Pilot wrote:



I search where is, in the engine, the PN 633309-8 (bearing needle).
I don't found yet in the IPC...


have you munged that part number?
633609-8 is a 'bearing, needle' which the overhaul manual puts as item
-21B on the drawing for that section.
if you flip back a page to figure 3 you'll find it on the item that
inserts on the lower left case half on the drawing.

I've never pulled it apart so I'm not sure what it is.

I think you are right.... but only an item number, no drawing.... It's
why I don't see.

thanks again.


what you need is a copy of the

Continental Aircraft Engines
Series C-75,85,90 & O-200
Service Parts Catalogue

this has exploded views of the group assemblies and a breakdown of the
parts that go into each assembly.

I just discovered that my read of the exploded view missed something.
the needle bearing in question is part of the starter clutch assembly.

if you cant find a copy I could scan it and sent a copy by email.
it is 58 pages.

Stealth Pilot
  #8  
Old August 17th 07, 08:53 PM posted to rec.aviation.homebuilt
Philippe Vessaire
external usenet poster
 
Posts: 49
Default O200 engine

Stealth Pilot wrote:


what you need is a copy of the

Continental Aircraft Engines
Series C-75,85,90 & O-200
Service Parts Catalogue


I own that, but the needles are not design and I did't found the the
PN in the list.

Thanks
--
Volem rien foutre al païs!
Philippe Vessaire Ò¿Ó¬
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Engine-out procedures and eccentric forces on engine pylons Mxsmanic Piloting 18 May 26th 07 01:03 AM
Saturn V F-1 Engine Testing at F-1 Engine Test Stand 6866986.jpg [email protected] Aviation Photos 1 April 11th 07 04:48 PM
F-1 Engine for the Saturn V S-IC (first) stage depicts the complexity of the engine 6413912.jpg [email protected] Aviation Photos 0 April 9th 07 01:38 PM
O200 nose Philippe Home Built 0 July 22nd 05 08:09 PM
1710 allison v-12 engine WWII p 38 engine Holger Stephan Home Built 9 August 21st 03 08:53 AM


All times are GMT +1. The time now is 09:34 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.