Question on Owner Produced Interior parts

Hello, every one well my first custom gps/cup holder mount was temporary
fitted today after an ok from my A&P/IA as no holes were needed to be
drilled in to the aircraft this mount replaced the brittle and cracked mike
mount.

Link to RAM mount cup Holder
http://rammount.com/ramwebcompthumb/ramb132b.jpg

6 hours of work went in to drawing up, and hand shaping drilling and taping
this little piece of alloy,

Here is the mount with RAM Mount ball installed ready for any ram-mount 1"
ball attachment,
http://www.warflying.net/gps2/m5.JPG

Here is the GPS On the mount,
http://www.warflying.net/gps2/m11.JPG

GPS with universal ram mount
http://www.warflying.net/smap/smap1.jpg &
http://www.warflying.net/smap/smap2.jpg

Cessna Seat Rail Mount
http://www.warflying.net/smap/smap3.jpg

http://www.warflying.net/smap/smap4.jpg


As you can see the seat rail mount with the 12" flex arm is to long and
interferes with the power controls I think a 9" flex arm would bring it down
to a nice level but then it would be in your legs not good. nice mount
though holds secure and great quality product may put it behind the seat and
use the 1/2" hole for a cam corder mount.
http://www.warflying.net/smap/smap5.jpg &
http://www.warflying.net/smap/smap7.jpg








"NW_PILOT" wrote in message
...
I was reading on http://150cessna.tripod.com about owner
manufactured parts. I was wondering if I could make my own interior
parts? For example change plastic parts to aluminum, or titanium
such as the plastic instrument bezels, mike holder ECT.

I have access to a really nice machine shop, CNC equipment, laser
cutter's and etchers ect. I can almost make/help make any plastic
part on the inside of the airplane out of aluminum or titanium.

Any advice on this!