|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#41
September 7th 20, 05:33 PM
posted to rec.aviation.soaring
|
|||
|
|||
Pawnee Tow Release
Dan,
I have posted 5 pictures he https://www.flickr.com/photos/15627832@N05/? The pictures show how the release cable is routed in our Pawnees for a TOST release. If you are using a Schweizer release then this won't work because you need a lot more leverage than you do for the Tost. Basically, the cable follows the left rudder cable up to the cockpit from the release, goes to a pulley on the floor and then goes vertically upwards to the bottom of the instrument panel. We have a golf ball (with a hole drilled through) through which the cable passes to act as a grab. You can either pull the cable aft, or push it forward to activate the Tost release. Hopefully, this is helpful. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Piper PA-25 Pawnee pics [04/11] - Pawnee pulls a glider.jpg (1/1) | Miloch | Aviation Photos | 0 | November 10th 18 03:53 PM |
| Piper PA-25 Pawnee pics [01/11] - A Swift glider is performing continuous full rolls while being towed by a Pawnee.jpg (1/1) | Miloch | Aviation Photos | 0 | November 10th 18 03:53 PM |
| Pawnee Tost Release | Mike125 | Soaring | 1 | April 16th 08 03:59 PM |
| Tow Release Handles for Pawnee and C182 | [email protected] | Soaring | 2 | March 12th 07 02:40 AM |
| WTB towhook release for Piper Pawnee | [email protected] | Soaring | 2 | November 22nd 06 03:29 PM |
Linear Mode
