If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#91
|
|||
|
|||
Sport Pilot wrote:
The model diesel engines will not turn as fast as the gas or methanol/nitro engines because the fuel (ether and kerosene) will not burn as fast. I say again: there is no magic rule that says "diesel burns slower" than gasoline. Increasing the boost pressure can increase the burn rate AS MUCH AS YOU WANT. Its just not done most of the time, because no one WANTS a 7000 RPM engine when a 4000 RPM engine is available to do the same job. People only build 7000 RPM engines when there's no other way to get the power. This is because the fuel burns slower, not because of the cycle, because all, the spark ignition gas engine, the glow plug methanol/nitro engine, and the compression ignition engine, are actually otto cycle engines. No, that's already been covered. Diesel (true diesel with either direct or pre-chamber injection) is a subtly different cycle than the Otto cycle. Its constant-pressure combustion instead of constant-volume combustion. |
#92
|
|||
|
|||
Steve writes:
Sport Pilot wrote: Why the obvious apple and orange comparision? To refute the statement that "more speed is more power." You need to compare engines of equal size. OK, Lets do it! Dodge 5.9 Liter v8 gasoline engine: 230 horsepower at ~5000 RPM Compared to: Dodge/Cummins 5.9 Liter turbo-diesel engine: 325 horsepower at 2900 RPM More speed is NOT more power any more than more torque at the same speed is more power. uh? More torque at the same speed *is* more power. power = torque * speed Had the gas engine produced the same torque at 5000 rpms as the diesel do at 2900, then it would have had about 560 hp at 5000. Thomas |
#93
|
|||
|
|||
"Thomas Tornblom" -to-reply wrote in message ... Steve writes: Sport Pilot wrote: More speed is NOT more power any more than more torque at the same speed is more power. uh? Yeah, that was my reaction! (?) ;-) More torque at the same speed *is* more power. power = torque * speed Had the gas engine produced the same torque at 5000 rpms as the diesel do at 2900, then it would have had about 560 hp at 5000. Thomas Actually, the equation to calculate power (or horsepower (HP) in this case) is HP = Torque X rpm / 5252. Torque being a measurable force that turns the crankshaft and ultimately the wheels, main rotor, or propeller (I just noticed that this is going to two aviation and one automotive newsgroups). Horsepower is defined as a "measurement" of work performed. By the equation, at least as it applies to internal combustion reciprocating engines, you can't have HP without torque! So, if you can increase the torque value at a given rpm, you'll increase the power output at that rpm. Likewise, if you can maintain a given torque value at a higher rpm, you'll produce more power in that case too. It doesn't matter what kind of engine you're talking about or the fuel burned. Gasoline, diesel, methanol, it makes no difference. The equation still applies. FWIW! Fly/Drive Safe, Steve R. |
#94
|
|||
|
|||
Steve wrote: Sport Pilot wrote: Why the obvious apple and orange comparision? To refute the statement that "more speed is more power." You need to compare engines of equal size. OK, Lets do it! Dodge 5.9 Liter v8 gasoline engine: 230 horsepower at ~5000 RPM Compared to: Dodge/Cummins 5.9 Liter turbo-diesel engine: 325 horsepower at 2900 RPM More speed is NOT more power any more than more torque at the same speed is more power. Steve, As you said power is torque * RPM, so for the same torque more speed is power. In fact with 0 RPM you have no power only a force. No I have not argued that desiels cannot deliver power by increasing torque. Only that their inherent design and fuel limits their maximum speed. Your example is a poor one most diesels of equivelant size will deliver more torque at less RPM and have less total horsepower. I don't know where you found that pitiful Dodge 5.9 liter engine. I have a 4.7 V8 in my Grand Cherokee and it puts out 260+ HP. I know that the 5.7 Liter hemi V8 puts out about 320 or so HP and it is not turbocharged. So that is a more equal comparison. Unlike the apple orange examples you put up. |
#95
|
|||
|
|||
Steve wrote: Sport Pilot wrote: The model diesel engines will not turn as fast as the gas or methanol/nitro engines because the fuel (ether and kerosene) will not burn as fast. I say again: there is no magic rule that says "diesel burns slower" than gasoline. Increasing the boost pressure can increase the burn rate AS MUCH AS YOU WANT. Its just not done most of the time, because no one WANTS a 7000 RPM engine when a 4000 RPM engine is available to do the same job. People only build 7000 RPM engines when there's no other way to get the power. This is because the fuel burns slower, not because of the cycle, because all, the spark ignition gas engine, the glow plug methanol/nitro engine, and the compression ignition engine, are actually otto cycle engines. No, that's already been covered. Diesel (true diesel with either direct or pre-chamber injection) is a subtly different cycle than the Otto cycle. Its constant-pressure combustion instead of constant-volume combustion. I was not quite correct if I said desiel fuel burns slower, it is however made to ignite better with desiel engines so that the fuel ignites spontanously when injected. The fuel burns slower because it is injected over a period of time. However, I may have been correct about the model fuel. There are diesel conversion heads for model glow engines. This replaces the head and glow plug with a head with a varible compression. You adjust the timing by adjusting the compression. The fuel is a mix of kerosene, ether, amyl nitrate, and oil. This fuel will ignite at a much lower temperature than true desiel fuel. The ether and amyl nitrate are the componets which ignite at a low temp. Though ether is extremely volatile it is not a very high energy fuel and I think it burns slowly. These converted engines will turn large propellers at slower speeds than the glow engines they were converted from. Another example of a high energy fuel that limits speed is nitromethane. Because it is a monopropellent the racers can pretty much inject as much as their ignition can ignite, except for hydrolocking. That is if more fuel is injected than the combustion chamber volume the engine will blow up. But nitro burns slowly so RPM is more or less limited to just over 10,000 RPM loaded. The slow burning is why you see huge flames coming out the exhaust. |
#96
|
|||
|
|||
On Tue, 24 May 2005 21:54:29 GMT, Thomas Tornblom
-to-reply wrote: Steve writes: Sport Pilot wrote: Why the obvious apple and orange comparision? To refute the statement that "more speed is more power." You need to compare engines of equal size. OK, Lets do it! Dodge 5.9 Liter v8 gasoline engine: 230 horsepower at ~5000 RPM Compared to: Dodge/Cummins 5.9 Liter turbo-diesel engine: 325 horsepower at 2900 RPM More speed is NOT more power any more than more torque at the same speed is more power. One BIG factor is being forgotten here. The diesel is turboed. This makes it roughly equivalent to an 8 liter engine at about 6psi boost. Any combustion engine produces power in proportion to the amount of air consumed. On a diesel it does not necessarily "consume" all the air that goes through it - but the maximum power output is definitely limitted by how much air can be put through it. A turbo can eisily double the amount of air an engine pumps through it at a given speed. Running an engine at double the speed also increases the amount of air going through the engine - not quite double due to reduced volumetric efficiency at speed. Double the CFM gives double the horsepower, before factoring in frictional losses and / or pumping losses. A naturally aspirated diesel engine generally produces less HP per unit of displacement, but more torque at low RPMs due in part to less pumping loss (no air throttle) uh? More torque at the same speed *is* more power. power = torque * speed Had the gas engine produced the same torque at 5000 rpms as the diesel do at 2900, then it would have had about 560 hp at 5000. Thomas |
#97
|
|||
|
|||
Steve wrote:
Sport Pilot wrote: The model diesel engines will not turn as fast as the gas or methanol/nitro engines because the fuel (ether and kerosene) will not burn as fast. I say again: there is no magic rule that says "diesel burns slower" than gasoline. Increasing the boost pressure can increase the burn rate AS MUCH AS YOU WANT. Its just not done most of the time, because no one WANTS a 7000 RPM engine when a 4000 RPM engine is available to do the same job. People only build 7000 RPM engines when there's no other way to get the power. Hydrogen, for example, is a very rapid burning fuel. Hydrogen can and has been used in Diesels. I also suspect that natural gas, another common diesel fuel, burns at a high rate. The slow burn rate with many liquid diesel fuels is due to the time it takes the surface area of the droplets to vaporize. |
#98
|
|||
|
|||
|
#99
|
|||
|
|||
Don Stauffer wrote:
SOME diesels are turboed. Many are not. Some Diesels are normally aspirated. Some are supercharged with geared chargers. Some are turboed. It is by far an overgeneralization to claim that all Diesels are supercharged, even more so to say they are all turbo-supercharged. You forgot supercharged plus turbocharged http://www.wilksch.com/ -- Pub: http://www.slowfood.fr/france Philippe Vessaire Ò¿Ó¬ |
#100
|
|||
|
|||
Thomas Tornblom wrote:
Steve writes: Sport Pilot wrote: Why the obvious apple and orange comparision? To refute the statement that "more speed is more power." You need to compare engines of equal size. OK, Lets do it! Dodge 5.9 Liter v8 gasoline engine: 230 horsepower at ~5000 RPM Compared to: Dodge/Cummins 5.9 Liter turbo-diesel engine: 325 horsepower at 2900 RPM More speed is NOT more power any more than more torque at the same speed is more power. uh? huh. Read it again. More torque at the same speed *is* more power. That's exactly what I've been saying. You can get more power by increasing torque OR rpm or both. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2-stroke diesel is the (near) future? | Max Kallio | Home Built | 134 | July 18th 05 12:39 AM |
BSFC vs gas mileage, 2 stroke vs 4 stroke | Jay | Home Built | 10 | August 24th 04 02:26 PM |
Diesel Jodel information..........and .........diesel plane groups | Roland M | Home Built | 1 | January 4th 04 04:04 AM |
Diesel engines for Planes Yahoo Group Jodel Diesel is Isuzu Citroen Peugeot | Roland M | Home Built | 3 | September 13th 03 12:44 AM |
Diesel engines for Planes Yahoo Group Jodel Diesel is Isuzu Citroen Peugeot | Roland M | Rotorcraft | 2 | September 13th 03 12:44 AM |