Flarm picking up my transponder

On Thursday, April 23, 2020 at 3:10:51 PM UTC+2, Rob Cluxton wrote:
I apologize in advance if this has been discussed befo

My PowerFlarm core (LX9000) is picking up my Mode-S transponder as traffic about a mile out, same altitude. Any suggestions?

Thanks in advance,
Rob Cluxton
4D

As was mentioned correctly, if you have v7.00 installed, please downgrade to v6.83, as there is an issue with the detection of the own XPDR. If you don't use Mode-C (MODEC=0), then 7.00 should be fine, too.

Also mentioned, v7.00 detected a tow train situation with the tug only outputting ADS-B (not FLARM).

FLARMNet does not influence alarm behavior.

This, unfortunately, puts us into the position where we cannot currently offer a fix for the tow train alarms. We are working on a fix, though we rely on a supplier to fix their stuff first.

- Urban, FLARM