|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 14th 05, 03:01 AM
|
|||
|
|||
Pawnee window frame
Does anyone have a source for windows frames for a Pawnee? The hinges
are a weak point. The point where the hinge is welded to the frame develops cracks. I'm sure others have had the problem. Thanks Charlie 
|
|
#2
July 14th 05, 01:41 PM
|
|||
|
|||
|
Adding additional weld on inside of hinge in addtition to outer edge
solves problem permanently, unless failure is due to rust in bottom tube. UH
|
|
#3
July 14th 05, 04:30 PM
|
|||
|
|||
|
The bottom tube on the left side is rusted. I guess we can always make
a jig, and create our own. Thanks Charlie
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pawnee hell | Stewart Kissel | Soaring | 17 | October 27th 04 04:15 AM |
| Cirrus canopy frame repair | Louw Pieters | Soaring | 0 | May 29th 04 06:09 AM |
| FS: Piper Side Window (New) | JimC | Aviation Marketplace | 0 | August 10th 03 12:19 PM |
| FS Pawnee tugs | Robert Danewid | Soaring | 0 | August 9th 03 09:51 AM |
| Fitting canopy frame to fuselage advice | Deputy Dog | Soaring | 5 | July 27th 03 04:08 AM |
Linear Mode
