If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Aluminum tube, 2.25" ID
"Longez (AT) bigfoot (DOT) comwithoutthespamblocker"
wrote in message ... I'm trying to find some aluminum tube for part of an induction system I'm working on. I'd like it to be a weldable alloy like 6061, but it doesn't have to be. The important thing is the ID - I need 2 1/4 inches. I think the best shot is get 2.5"x.125 wall, and turn it down some. Any ideas for a source? How's this: http://www.luminum.com/tube/t6061-t6t.html Rick Pellicciotti http://www.belleairetours.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Opinions on Azusa aluminum wheels/brakes/axles? | RTW | Home Built | 2 | July 17th 03 04:19 PM |