If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Piper PA-25 Pawnee
https://en.wikipedia.org/wiki/Piper_PA-25_Pawnee The PA-25 Pawnee was an agricultural aircraft produced by Piper Aircraft between 1959 and 1981. It remains a widely used aircraft in agricultural spraying and is also used as a tow plane, or tug, for launching gliders or for towing banners. In 1988 the design rights and support responsibility were sold to Latino Americana de Aviación of Argentina. Most agricultural aircraft before 1949 were converted military aircraft and it was in that year that Fred Weick based at Texas A&M University designed a dedicated agricultural aircraft the AG-1, the AG-1 first flew on 1 December 1950. During 1953 Fred Weick was approached by Piper to become a consultant on the agricultural version of the PA-18 the PA-18A, in particular to design and test a distributor for dust and seeds. A few weeks later Piper sponsored Texas A&M University to design a dedicated agricultural aircraft based on the AG-1 but to use as many PA-18A and PA-22 components as possible, the resulting design the AG-3 was smaller than the AG-1 and had a steel tube fuselage and was fabric covered. The AG-3 was a single-seat low-wing monoplane with the wings braced to the fuselage with struts, it had a conventional landing gear with a tailwheel and was powered by a 135 hp engine. The single seat was placed high in the fuselage to give the best visibility and an 800 lb-capacity hopper was fitted in front of the cockpit. The aircraft's flying tests were successful and in 1957 Weick was invited to join Piper at Vero Beach and the AG-3 was renamed the PA-25 Pawnee. The engine was upgraded to a 150 hp Lycoming O-320-A1A engine. Two pre-production aircraft were built at Vero Beach in 1957 and production started at Lock Haven in May 1959. In 1962 another prototype was built at Vero Beach with a 235 hp Lycoming O-540-B2B5 engine and production aircraft were produced at Lock Haven from 1962. In 1964 the Pawnee B was introduced with a larger hopper and improved dispersal gear. The Pawnee C of 1967 was fitted with oleo shock-absorbers and other improvements; also in 1967, a 260 hp variant was introduced. Role Agricultural aircraft National origin United States Manufacturer Piper Aircraft Designer Fred Weick First flight 1957 Introduction August 1959 Produced 1959-1981 Number built 5167 In 1962 another prototype was built at Vero Beach with a 235 hp Lycoming O-540-B2B5 engine and production aircraft were produced at Lock Haven from 1962. In 1964 the Pawnee B was introduced with a larger hopper and improved dispersal gear. The Pawnee C of 1967 was fitted with oleo shock-absorbers and other improvements; also in 1967, a 260 hp variant was introduced. Early models of the Pawnee had a single fuel tank located between the agricultural hopper and the engine. The National Transportation Safety Board recommended to Piper Aircraft that the early model PA-25's with a fiberglass fuel tank be retrofitted with a rubber fuel cell to minimize the chance of catastrophic failure and fire resulting from a crash. In 1974 the Pawnee D was introduced with the fuel tanks moved from the fuselage to the wings, the 260 hp variant was also available with either a fixed pitch or constant-speed propeller. Although still the same design as the "D", the 1980 and 1981 production aircraft were marketed as the Pawnee. The final production aircraft was completed at Lock Haven on 22 March 1981, the last of 5,167 Pawnees. A useful design aspect was the ability to carry a mechanic on a jump seat fitted in the hopper to assist with operations at remote stations. On April 15, 1988, Piper Aircraft, Inc. officially sold the PA-25 series aircraft to Latino Americana de Aviación S.A in Argentina. The sale included all drawings, engineering data, parts inventory, tools, catalogs, and manuals. All support of any nature became the responsibility of the new owners. Specifications (PA-25-235 Pawnee) General characteristics Crew: One Capacity: 150 US gal (568 l) or 1,500 lb (545 kg) of chemicals Length: 24 ft 9 in (7.55 m) Wingspan: 36 ft 2 in (11.02 m) Height: 7 ft 2 in (2.19 m) Wing area: 183 ft² (17.0 m²) Empty: 1,457 lb (662 kg) Loaded: 2,900 lb (1,317 kg) Maximum takeoff: 2,900 lb (1,317 kg) Powerplant: 1 x Lycoming O-540-B2B5, 235 hp (175 kW) Performance Maximum speed: 107 kts or 124 mph (188 km/h) Range: 300 miles (500 km) Service ceiling: 13,000 ft (3,963 m) Rate of climb: 630 ft/min (192 m/min)(at MTOW) Wing loading: 15.9 lb/ft² (77.5 kg/m²) Power/Mass: 0.0810 hp/lb (0.133 kW/kg) * |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted: Piper Pawnee PA 25-235 | [email protected] | Soaring | 0 | April 22nd 18 10:47 PM |
Piper Pawnee brake | [email protected] | Soaring | 2 | October 19th 12 01:20 PM |
Wanted: Piper Pawnee | Tim Hanke | Soaring | 2 | May 17th 10 06:37 PM |
Piper Pawnee flying characteristics | Mike A | Soaring | 5 | March 18th 07 08:35 PM |
Piper Pawnee Parts | Rod Pool | Soaring | 3 | February 3rd 04 11:12 PM |