If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
bendix carb question
My old C-85 has a Bendix Stromberg NA-S3A1, which is leaking for a time
after shutdown. Previous owner of the plane had tied off the mixture control so shutdown is by reduced throttle and magnetos turned off. Casual conversations are leaning towards a needle seat or float level problem. Any other possibilities? Not knowing how the mixture control works inside the carb body and not finding any carb parts breakdown pictures or float setting information around in the chapter library today and having carb accessable with the cowling off, can I just remove the airbox and then what appears to be the float bowl for some kind of inspection?? I did see that A.S.S. has an overhaul manual and some pretty pricey needles but am hoping to get back into the air sooner. Can anyone help? Float setting procedure and needle inspection. Thanks, Dick |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Have you ever experienced carb ice with an injector carb? | flybynightkarmarepair | Home Built | 1 | January 31st 05 01:48 AM |
Induction System Water Problem | Mike Spera | Owning | 1 | January 30th 05 05:29 AM |
Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 07:26 PM |
Bendix drives. | JDupre5762 | Home Built | 6 | May 16th 04 01:23 PM |
Carb Temperature Gauge | fly_the_skies | Home Built | 6 | January 14th 04 03:32 PM |