|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 8th 03, 09:23 PM
|
|||
|
|||
TTF (trying to flog) Sperry SP20 gyropilot amplifier assembly. C130
put it on ebay
http://cgi.ebay.com/ws/eBayISAPI.dll...m=2426570 431 but it's either... uninteresting or priced wrong what do you think scrap metal/rob the parts/or something that someone could use... tnx -t 
|
|
#2
August 8th 03, 11:55 PM
|
|||
|
|||
|
"tongaloa" wrote in message ... put it on ebay http://cgi.ebay.com/ws/eBayISAPI.dll...m=2426570 431 but it's either... uninteresting or priced wrong what do you think scrap metal/rob the parts/or something that someone could use... FAA TSO 10b is for an altimeter, so I'll go with the ad being bull****.
|
|
#3
August 9th 03, 12:59 AM
|
|||
|
|||
|
Thanks for comments.
I pulled info off nomenclature plate. Looked up pn with google and it crossed to the NIIN listed as amplifier. It does have a port so you may be right. 35 lb seems a bit much for 'just an altimeter'... Will cannibalize if that's all it turns out to be. Can use the sensor for a project... -Bob Tarver Engineering wrote: "tongaloa" wrote in message ... put it on ebay http://cgi.ebay.com/ws/eBayISAPI.dll...m=2426570 431 but it's either... uninteresting or priced wrong what do you think scrap metal/rob the parts/or something that someone could use... FAA TSO 10b is for an altimeter, so I'll go with the ad being bull****.
|
|
#4
August 9th 03, 01:02 AM
|
|||
|
|||
|
Tarver Engineering wrote: FAA TSO 10b is for an altimeter, so I'll go with the ad being bull****. My goof. It's FAA TSO 9b Right there on the plate. Don't know how, transcribed as a 10... So what do you think? Rob the parts or look for a home?
|
|
#5
August 9th 03, 05:06 AM
|
|||
|
|||
|
I have repaired my share of those. You are better off converting a blind
encoder. The amp for auction is 1950 - 1960s technology with about a dozen tubes. For all usable parts I'd go no higher than $40 or $50 since it is useless as AFCS in anything other than the system it was intended for. Dan, U. S. Air Force, retired Subject: TTF (trying to flog) Sperry SP20 gyropilot amplifier assembly. From: tongaloa Date: 8/8/2003 6:59 PM Central Daylight Time Message-id: Thanks for comments. I pulled info off nomenclature plate. Looked up pn with google and it crossed to the NIIN listed as amplifier. It does have a port so you may be right. 35 lb seems a bit much for 'just an altimeter'... Will cannibalize if that's all it turns out to be. Can use the sensor for a project... -Bob
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Kinda OT but... Trying to flog a Sperry SP 20 autopilot servo ampfor C130... | tongaloa | Home Built | 0 | August 8th 03 07:45 PM |
| Sperry SP20 Gyropilot amplifier assembly | tongaloa | Aviation Marketplace | 0 | August 8th 03 07:38 PM |
Linear Mode
