|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 2nd 14, 07:02 PM
posted to rec.aviation.soaring
|
|||
|
|||
Oudie2 - V7 - PowerFlarm Core setup (cabling question)
The V7 manual shows a few sample configurations, but not one with a PowerFlarm Core.
Are any special cables required? Does the PF Core get its power through the V7 or does it require its own? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Powerflarm Brick/Core ADSB Range | Sean F (F2) | Soaring | 3 | September 5th 13 03:10 PM |
| Momentary GPS data dropouts with PowerFLARM to SN10A to Oudie2 setup | kirk.stant | Soaring | 8 | May 7th 13 03:06 PM |
| PowerFLARM core external display software update | kirk.stant | Soaring | 5 | January 28th 13 08:56 PM |
| tailwheel setup question | Dick[_1_] | Home Built | 2 | May 20th 08 11:20 AM |
| Newbie question on trailering Setup | joe | Soaring | 11 | December 26th 04 11:10 PM |
Threaded Mode