|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 4th 06, 09:48 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Breather Tube Size For IO-540?
Installing a 540 in a Skybolt and running the obligatory breather tube along
the length of the fuselage and out the rear in the usual manner. Was planning on a 3/4" diameter tube, is that big enough? TIA, Scott 
|
|
#2
May 5th 06, 12:06 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Breather Tube Size For IO-540?
On Thu, 04 May 2006 20:48:47 GMT, "Scott Rodriguez"
wrote: Installing a 540 in a Skybolt and running the obligatory breather tube along the length of the fuselage and out the rear in the usual manner. Was planning on a 3/4" diameter tube, is that big enough? TIA, Scott how much do you think is pumping out that breather tube? surely half inch would be adequate. what size is the fitting the tube attaches to? Stealth Pilot
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hilsch Tube for Cabin Temp control... | EridanMan | Home Built | 8 | April 11th 06 03:17 PM |
| Rag and tube construction and computer models? | BllFs6 | Home Built | 24 | April 12th 04 12:20 PM |
| Why 4130 tube? | Leon McAtee | Home Built | 31 | March 28th 04 03:04 PM |
| Pitts Special Steel Tube Fuse Mod. | Martin Morgan | Home Built | 0 | November 23rd 03 11:08 PM |
| Chuck Yeager-pitot tube | Ron | Military Aviation | 44 | October 9th 03 03:13 AM |
Linear Mode
