A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Soaring
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Cup holder



 
 
Thread Tools Display Modes
  #1  
Old October 19th 17, 09:37 PM posted to rec.aviation.soaring
[email protected]
external usenet poster
 
Posts: 20
Default Cup holder

Has anyone installed a cup holder on their glider? Pictures?
  #2  
Old October 19th 17, 10:14 PM posted to rec.aviation.soaring
Charlie M. (UH & 002 owner/pilot)
external usenet poster
 
Posts: 1,383
Default Cup holder

I used 1quart Gatorade bottles, until they downsized.
Camelback is a great, easy to do, option.

BTW, I sometimes used the empty bottles as a relief place, but didn't drop over the side.
Paid to use "Hawaiian punch" bottles so the fluid color didn't mess anyone up later......LOL.....
(Yeh, don't do mango or similar......) ;-)
  #3  
Old October 20th 17, 04:01 PM posted to rec.aviation.soaring
[email protected]
external usenet poster
 
Posts: 77
Default Cup holder

On Thursday, October 19, 2017 at 1:37:18 PM UTC-7, wrote:
Has anyone installed a cup holder on their glider? Pictures?


You mean the co-pilot?
  #4  
Old October 20th 17, 07:37 PM posted to rec.aviation.soaring
Roy B.
external usenet poster
 
Posts: 304
Default Cup holder

On Thursday, October 19, 2017 at 4:37:18 PM UTC-4, wrote:
Has anyone installed a cup holder on their glider? Pictures?


What I need is a place to keep my chopsticks (for the Sushi) clean when I am busy landing out . . .
ROY
  #5  
Old October 20th 17, 09:19 PM posted to rec.aviation.soaring
Dan Marotta
external usenet poster
 
Posts: 4,601
Default Cup holder

....And your Grey Pupon?

On 10/20/2017 12:37 PM, Roy B. wrote:
On Thursday, October 19, 2017 at 4:37:18 PM UTC-4, wrote:
Has anyone installed a cup holder on their glider? Pictures?

What I need is a place to keep my chopsticks (for the Sushi) clean when I am busy landing out . . .
ROY


--
Dan, 5J
  #6  
Old October 20th 17, 10:07 PM posted to rec.aviation.soaring
[email protected]
external usenet poster
 
Posts: 580
Default Cup holder

At an important contest many years ago--before we all started using flexible water containers with drinking tubes--my mother/crew prepared my sandwich (this was also WAY before energy bars) and a 16 oz. Tupperware cup with a plastic snap-on lid full of Coke and ice cubes. I wedged it down by my side to keep it upright.

I almost lost it at 5,000 ft. on course when B-O-O-O-O-M!!!!--the top blew off from the combined effects of carbonation and reduced air pressure. OK, maybe it only seemed that loud because there was no warning. In any case, Coke went everywhe on me, on the cockpit walls, on the instrument panel, but mostly up on the inside of the canopy. Try wiping off sugary soda with the paper napkin that was previously wrapped around a peanut butter sandwich.

Yeah, I can see the utility of cup holders, but only if they have some sort of safety lock.

Chip Bearden
  #8  
Old October 22nd 17, 09:22 PM posted to rec.aviation.soaring
[email protected]
external usenet poster
 
Posts: 465
Default Cup holder

A few years back I was flying with a Camelback with its spout that you pinch in your mouth to let the water out. Somehow that spout got caught under me, and by the time I noticed anything I was already sitting in a tub of water. "Fly the airplane"... Since then I've added the valve Camelback offers, to shut off any possible flow while I am not drinking. Perhaps should also drill a drain hole in the seat pan?
  #9  
Old October 22nd 17, 09:26 PM posted to rec.aviation.soaring
Darryl Ramm
external usenet poster
 
Posts: 2,403
Default Cup holder

You are not the first to sit on a bite valve and get wet. The twist valve is critical. Installing Camelbak hose mounting clips onto the side of the fuselage also helps.
  #10  
Old October 20th 17, 10:14 PM posted to rec.aviation.soaring
[email protected]
external usenet poster
 
Posts: 478
Default Cup holder

Had a toaster oven in my glider for inflight reheating of meatball sandwiches, was a hassle. Easy now, I just toss them on the transponder.
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Looking for Steve Harris (ex world altitude record holder) Sean[_2_] Soaring 4 December 23rd 16 10:54 PM
Need pictures of Komet Trailer Elevator Holder Scott Alexander[_2_] Soaring 0 July 25th 12 08:50 PM
taller battery holder/clips for Ventus 2? Frank[_12_] Soaring 16 October 9th 10 04:57 AM
L13A Type certificate holder Bruce Soaring 7 August 19th 10 07:01 PM
FA: Beech aircraft yoke chart holder (Garhawk) Karl Geng, N1DL Products 0 January 28th 05 08:07 PM


All times are GMT +1. The time now is 01:54 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.