If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
help with an ILEC SB-9
I bought a glider which had been in storage for some time. It has an ILEC SB-9 vario which does not appear to be functioning.
When I power on the vario, the needle climbs to the one knot up position and stays there continually while beeping. It does this regardless of which position the mode switch is set to. Gently applying pressure or suction to the pitot causes the other vario (Cambridge 302) to respond, but the ILEC does not respond at all. I have removed the old rechargeable 9v battery from the ILEC with no change in behavior. Are there troubleshooting steps I should attempt before I remove this vario? Matt |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: ILEC SN-10 | AJM | Soaring | 2 | June 19th 14 03:45 AM |
Ilec MCU | Mark Jardini | Soaring | 1 | July 18th 08 11:21 PM |
FS: Ilec SB-9 (US) | [email protected] | Soaring | 0 | December 2nd 06 11:44 AM |
FS - ILEC SB-7 | Jim Hendrix | Soaring | 0 | August 5th 05 09:08 PM |
FS-Ilec SC-7 | Glen Kelley | Soaring | 0 | March 22nd 05 03:50 PM |