|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Bendix Magneto Question
I have an engine going into a homebuilt that uses the bendix D-2000 series
dual magneto. I have ordered a crank triggered ignition system to fire one
set of plugs and would like to replace the dual magneto with a single
magneto to fire the other set of plugs. The Starting functions will be
accomplished using the Electronic system so I do not need an impulse
coupling or retard breaker.
DOES ANYONE KNOW THE APPLICABILITY OF SINGLE MAGS TO REPLACE A DUAL MAGNETO?
THAT IS, WHICH SINGLE MAG WOULD REPLACE MY DUAL?
IF NOT, DOES ANYONE HAVE A CONTACT AT BENDIX THAT MIGHT BE ABLE TO ANSWER MY
THANKS IN ADVANCE!
Mag Type: D6RN-2230
Mag Part # 10-382610-121
System Part # 10-385286-401
|Thread||Thread Starter||Forum||Replies||Last Post|
|Bendix Magneto Question||Dick Kurtz||Home Built||1||September 22nd 05 08:51 AM|
|Bendix Magneto Question||Dick Kurtz||General Aviation||0||September 22nd 05 03:36 AM|
|Bendix Magneto Question||Dick Kurtz||Owning||0||September 22nd 05 03:36 AM|
|Bendix S4RN21 magneto||Heino & Deanne Weisberg||Home Built||0||August 12th 05 05:55 AM|
|bendix carb question||Dick||Home Built||11||June 25th 05 05:15 AM|