Shadin flowmeter problems - anyone else sees this?

"Peter" wrote in message
...

I've had a Shadin Microflo for a year and a half, and it has what
looks like a hardware or software bug: after setting a new FOB figure,
waiting for it to save it, turning off power, turning power back on,
it has lost the new FOB setting and has reverted to the original FOB
setting which was there before I started to change it.

Yes. I think I've seen that on a Digiflo. I put it down to finger trouble
but it happened twice.

Interestingly, after you program the Full setting (rarely used in practice),
the manual advises

"NOTE: Do not turn the power off to the computer for
approximately one minute. This will ensure that the unit has
enough time to store the proper figures into the program."

but it doesn't explicitly say the same for normal pre-flight ops.

Julian Scarfe