|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 16th 04, 02:47 PM
|
|||
|
|||
John in Kentucky Asks
Where can I find a set of pistons to hop up an O-200?
Answer: John, use stock C-85 pistons. They are 3/8" higher than O-200 pistons and will give you that "pop-up" effect, that is, a little higher compression. Not legal, of course, in a certified aircraft, or aircraft engine you plan to leave the data plate on. For more secrets on blueprinting and tuning the O-200 for speed and power, see the guys who race them at Reno. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Big John Bites Dicks (Security Clearance) | Badwater Bill | Home Built | 27 | August 21st 03 12:40 AM |
Linear Mode
