If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Any metallurgist's on the group, I want to heat treat aluminum?
Hi,
New to this group and figured I would post a question. Wondering if there are any metallurgist's on this group, or someone who knows how to heat treat aluminum? What I've got is 2024 in a "O" rating and would like to heat treat it to at least a T3, if not higher. Thickness's I am working with are .032 / .063 /.080. I know there is a way to do this with an oven and heat. I have access to an oven that is programable and could melt aluminum. It is also programable to step down in stages, for desired times and temps. Anyone know how to do this? Thanks, Matt |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Carb heat specs? | Rich S. | Home Built | 2 | November 13th 04 04:39 PM |
Painting and air cooled motor? | CitizenX | Home Built | 5 | June 30th 04 12:47 PM |
28 volt pitot heat | B2431 | Home Built | 15 | April 17th 04 03:25 PM |
Heat treating wing ribs | Holger Stephan | Home Built | 13 | February 3rd 04 11:59 PM |
News server problems on just this group | Chris W | Home Built | 9 | August 9th 03 02:32 AM |