|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 4th 04, 09:18 PM
|
|||
|
|||
Dacron
I had a wing stored for a couple of weeks. I thought it was resting on the
leading edge tube but a part of it was resting on a 2x4 on the Dacron fabric. It put about a 2" pucker in the fabric and hasn't come out. Can Dacron be shrunk with an iron like the polyester used in Poly-Fiber System? 
|
|
#2
January 4th 04, 11:56 PM
|
|||
|
|||
|
Yes, if it hasn't already been completely shrunk.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
