2-32 Canopy Needed

Does anyone have a lead on a replacement SGS 2-32 canopy. Ours is going to need to be replace before too much longer.

Thanks

On Jan 10, 5:53*pm, SoaringNV wrote:
Does anyone have a lead on a replacement SGS 2-32 canopy. *Ours is going to need to be replace before too much longer.

Thanks

Check K&L first, but I know that the place in LA (http://
www.ceebaileys.com/) is FAA/PMA approved and has molds for the
1-26/2-33. I have seen and installed their 1-26 canopy and it was
very well done. Most folks vastly underestimate the work involved in
locating and drilling the attach holes, the Cee Baily products are
predrilled. I believe Cee Baily has done the 2-32 before, but since
this one is moldless and free blown, I have seen some pretty bad
aftermarket canopies. At the least, you want to make a few templates
to make sure it has the right contour, and you don't end up with not
enough headroom. If the countour of your present canopy is off, as is
the one on 9851E, you might contact the owners of the "New" 2-32 at
Crystal with the original canopy, You could ask them to make a few
measurements for you.

Please email pa12joeataol.com

On Thursday, January 10, 2013 at 6:53:46 PM UTC-7, SoaringNV wrote:
Does anyone have a lead on a replacement SGS 2-32 canopy. Ours is going to need to be replace before too much longer.

Thanks

Are you still in the market for a 2-32 canopy?

Mike 303-817-2097