If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#51
|
|||
|
|||
VOR technigue, don't overshoot
Anthony, at least it looks like he has a plane and flies- what about you?
|
#52
|
|||
|
|||
VOR technigue, don't overshoot
Anthony said: Prove it. Answer your own questions, for a start. It's always useful to share knowledge. Anthony, why do you keep posting, when you should realize by now that every time you make a single post, you will never receive an answer or a positive response to what you've written? This is because you lack credibility and experience, and are therefore disrepected. This will never change unless the unlikely event occurs when you actually fly an airplane and gain experience. Until then, you will always be treated as the pompous wannabe you are. |
#53
|
|||
|
|||
VOR technigue, don't overshoot
Beauciphus writes:
Trying to become an internet tough-guy? No, just calling someone's bluff. |
#54
|
|||
|
|||
VOR technigue, don't overshoot
No, just calling someone's bluff. Anthony, how would you know whether he was bluffing or not? Just a few months ago you were askiing the location of the ejection seat switch on a Baron! (We all know it's like an Aces II, just pull the yellow and black ring between your legs). Of course, it's not visible on MSFS, so this is why you probably missed it. |
#55
|
|||
|
|||
VOR technigue, don't overshoot
"Mxsmanic" wrote in message
... Beauciphus writes: Trying to become an internet tough-guy? No, just calling someone's bluff. It really doesn't matter if he know or not. You are not worthy of an answer. |
#56
|
|||
|
|||
VOR technigue, don't overshoot
Viperdoc writes:
... how would you know whether he was bluffing or not? Someone who is bluffing will never answer the question, despite the obvious advantages of doing so. |
#57
|
|||
|
|||
VOR technigue, don't overshoot
"Mxsmanic" wrote in message
... Viperdoc writes: ... how would you know whether he was bluffing or not? Someone who is bluffing will never answer the question, despite the obvious advantages of doing so. I see no advantage. I have no interest in the answer, and most real pilots wouldn't. It's simply trivia. |
#58
|
|||
|
|||
VOR technigue, don't overshoot
Someone who is bluffing will never answer the question, despite the
obvious advantages of doing so There is no advantage in doing so, since any pilot would obviously know the answer. The premise of your logic is flawed, and based upon the fact that you do not understand anything near to what you think about flying, since you have no experience. You are not worth the time or effort to formulate a considered or respectful answer, and this is why you will always be castigated on this and other NGs. |
#59
|
|||
|
|||
VOR technigue, don't overshoot
Beauciphus writes:
I see no advantage. I have no interest in the answer, and most real pilots wouldn't. It's simply trivia. It apparently wasn't trivia when I was asked. When did its status change? |
#60
|
|||
|
|||
VOR technigue, don't overshoot
Viperdoc writes:
There is no advantage in doing so, since any pilot would obviously know the answer. Then there is no point in asking me the same questions, is there? And it's a bit contradictory to refuse to answer a question and then criticize someone else for not answering it, isn't it? You are not worth the time or effort to formulate a considered or respectful answer, and this is why you will always be castigated on this and other NGs. You post to me regularly even though I usually don't even respond, so obviously it's worth a great deal to you. You do realize how transparent this is, don't you? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Overshoot in Honduras? | Mike Isaksen | Piloting | 12 | June 2nd 08 01:53 PM |
Hawk overshoot [1/1] | Peter Twydell | Aviation Photos | 0 | March 25th 08 07:20 PM |