![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
It just seemed to me that a 2-letter prefix would hasten the search for
a particular wire without going through 100-200 Numbers only |
#2
|
|||
|
|||
![]() "Jerry Wass" wrote in message .. . It just seemed to me that a 2-letter prefix would hasten the search for a particular wire without going through 100-200 Numbers only Unless you worked on said wires every day, it would still necessitate looking at the wires with a chart in your hand, to remember what DB and DE actually run to. That being the case, if you are using colored shrink tube, just put it like it is on the chart. No translating necessary. Something like BBYR compass BBRBl gyro -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
wiring | Jerry Wass | Home Built | 7 | January 3rd 09 09:03 PM |
Wiring--Help! | Jerry Wass | Home Built | 0 | January 2nd 09 03:12 AM |
Q about mic wiring | ken ward | Soaring | 2 | May 31st 05 10:33 PM |
Wiring KX 175 TSO | Tore B. | General Aviation | 0 | May 6th 04 10:02 PM |
Wiring KDR-510 | Chad Lemmen | Owning | 3 | September 16th 03 02:03 PM |