If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
PIREP Needed - Aircraft Door Seals Instrument Panel cover
Anyone purchase one of these for their Cherokee? They tell me that
removal of the existing panel is easy and the total job (including remounting the defroster ducts) will take no more than 2 hours. For the life of me, I cannot see how it can be that easy. The padded lip is mounted SOLIDLY to the instrument panel, although I cannot see how. The padded underside lip material was stretched and riveted. Where are the mounting screws? Do you have to crawl under the instrument panel to get at them? If so, there is no way 2 hours would cover the R&R of this beast. I can see the front lip is pushed into the extruded aluminum molding. They say this can stay. So, it appears their solution completely covers the irregular top forward surface with a smooth flat top. Getting at the defroster 6/32 screws look like a real adventure. How about it? Anyone been through this? Thanks, Mike |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Washington DC airspace closing for good? | tony roberts | Piloting | 153 | August 11th 05 12:56 AM |
Boeing Boondoggle | Larry Dighera | Military Aviation | 77 | September 15th 04 02:39 AM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | June 2nd 04 07:17 AM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | May 1st 04 07:29 PM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 2 | February 2nd 04 11:41 PM |