|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 10th 04, 01:30 AM
|
|||
|
|||
RT-540A question for jim Weir
Do you have a "sharable" pin-out for a ARC- Rt-540A radio?
We got one donated for the CAP to use as a basestation- but all cables were cut with no labels.. Bill in NJ 
|
|
#2
December 10th 04, 09:48 PM
|
|||
|
|||
|
No, but I think Bob Nuckolls has the pinout on his website, if I could only
remember the URL. www.aeroelectric.com I think Jim "Billc851" wrote in message ... Do you have a "sharable" pin-out for a ARC- Rt-540A radio? We got one donated for the CAP to use as a basestation- but all cables were cut with no labels.. Bill in NJ
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question for Jim Weir | Ed Sullivan | Home Built | 9 | September 21st 04 11:45 AM |
| Avionic question for Mr. Jim Weir | Henning DE | Home Built | 4 | September 19th 04 09:07 AM |
| Question | Charles S | Home Built | 4 | April 5th 04 09:10 PM |
| Inverter question for Jim Weir | B2431 | Home Built | 35 | February 27th 04 09:28 PM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
Linear Mode
