If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Oudie/Flarm alarm from my own ADS-B/Transponder
I recently installed a Trig TT22 transponder in our LS6. Today I got to fly it for the first time and I was getting constant conflict alarms on my Oudie about traffic at (for e.g.) my "6 O'Clock and 35ft above me" The only way I could figure out how to silence these alarms was to set my transponder to "ON" (i.e. no altitude reporting). Naturally my PAPR report showed a failure on both pressure and GPS altitude.
I've been trying to figure out how to configure either the FLARM or the Oudie to ignore my own emissions but so far with no luck. Does anyone out there know how to fix this? Rich L. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OUDIE FLARM | [email protected] | Soaring | 5 | July 12th 18 09:45 PM |
flarm/oudie | [email protected] | Soaring | 3 | September 15th 17 02:51 PM |
trying to work out how you connect the flarm view 57 to mini box flarm running a V7 and Oudie | Michael Marshall[_2_] | Soaring | 3 | April 10th 16 04:13 AM |
trying to work out how you connect the flarm view 57 to mini box flarm running a V7 and Oudie | Michael Marshall[_2_] | Soaring | 0 | April 8th 16 08:57 PM |
FLARM-V7-Oudie setup | dbrunone | Soaring | 10 | July 9th 13 08:27 PM |