If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Size of Allen Wrench used to secure horizontal of ASG-29
Anyone know the size of allen wrench used to secure the horizontal of an ASG-29?
|
#2
|
|||
|
|||
Size of Allen Wrench used to secure horizontal of ASG-29
At 20:49 30 October 2016, Jonathan St. Cloud wrote:
Anyone know the size of allen wrench used to secure the horizontal of an ASG-29? I just reach for my set of ball ended hex keys, metric..... I'm fairly sure there are other sizes somewhere around the machine, and if you have a sensible tool set you might become much sought after... |
#3
|
|||
|
|||
Size of Allen Wrench used to secure horizontal of ASG-29
On Sunday, October 30, 2016 at 2:49:28 PM UTC-6, Jonathan St. Cloud wrote:
Anyone know the size of allen wrench used to secure the horizontal of an ASG-29? Just checked my tool for the horizontal and its a 8 MM hex. Best. Tom. #711. |
#4
|
|||
|
|||
Size of Allen Wrench used to secure horizontal of ASG-29
Thank you much!
On Sunday, October 30, 2016 at 3:44:48 PM UTC-7, Tom Kelley #711 wrote: On Sunday, October 30, 2016 at 2:49:28 PM UTC-6, Jonathan St. Cloud wrote: Anyone know the size of allen wrench used to secure the horizontal of an ASG-29? Just checked my tool for the horizontal and its a 8 MM hex. Best. Tom. #711. |
#5
|
|||
|
|||
Size of Allen Wrench used to secure horizontal of ASG-29
Buy a half dozen from your favorite made in China supplier and
top up every spring. |
#6
|
|||
|
|||
Size of Allen Wrench used to secure horizontal of ASG-29
On Sunday, October 30, 2016 at 4:49:28 PM UTC-4, Jonathan St. Cloud wrote:
Anyone know the size of allen wrench used to secure the horizontal of an ASG-29? Aw, just find the old one: Turn the glider upside-down and give it a good shake. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Torque Wrench Calibration | [email protected] | Home Built | 18 | July 1st 09 01:39 PM |
Thin 3/8" wrench | RST Engineering | Home Built | 10 | November 17th 06 12:52 PM |
Flight wrench question | R.H. | Piloting | 14 | June 25th 06 03:48 PM |
Ignition lead nut-wrench | jerry wass | Aviation Marketplace | 0 | April 8th 06 03:55 AM |
Wrench size for KI214 & KI201 OBS knob | Roy Page | Owning | 7 | March 11th 05 10:07 PM |