|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#16
July 5th 11, 04:31 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Filament wound airfoils. (again)
----- Original Message -----
From: "Paul Saccani" Newsgroups: rec.aviation.homebuilt Sent: Monday, July 04, 2011 8:49 PM Subject: Filament wound airfoils. (again) You would be better off with a CH750 if that is your engine of choice. I thought that too, but they cross the line between "comfortably-trailerable" and "damn-near-impossible-to-trailer." Also, their STOL specs are (surprisingly!) a lot poorer than the 701. Some folks have put 0-200s into 701s with success, so it can be done. Also, the 750 would come perilously close to GA. Anyone know of any 701s flying around the Sydney/NSW area? -- Jeff R. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motor wound up. | stol | Home Built | 3 | September 23rd 10 01:38 AM |
| Walter Reed's Wound Warriors visit gliderport | Frank Whiteley | Soaring | 0 | July 11th 10 06:48 PM |
| Airfoils | [email protected] | Home Built | 4 | September 30th 06 09:14 AM |
| Re Eppler airfoils | Ronald E Baker | Soaring | 2 | November 4th 03 10:28 AM |
| Eppler airfoils | Dave Kuchenbecker | Soaring | 1 | October 23rd 03 03:14 PM |
Threaded Mode