If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#19
|
|||
|
|||
"...but I don't have a lathe."
Michael Horowitz wrote:
On 17 Aug 2005 10:57:42 -0700, wrote: "...but I don't have a lathe." in this article, Bob describes how to chuck something like a 2" washer (using a coupling) so that one can reduce the washer's diameter. I'm staring at a piece of 11/16" 4130 steel tubing, three inches long which is supposed to slip into a piece of 3/4 OD tubing and act as an inner sleeve. this inner-sleeve-to-be needs to be turned just a scooch so that it will fit. It seems to me that there must be a simply way to do this; I immediately go to to the most Rube Goldberg arrangement I can dream up. At the moment I'm thinking of turning down two washers so that they matches the ID of the work piece; that will keep the work centered on a piece of threaded rod. Open to other ideas - MIke If your live end cone is big enough that takes care of that end. A wood dowel forced into the other end takes care of that end. Make your own dowel and LEAVE it in the chuck when you put the tube over it. If you move the wood it will never again be true to you. If you'd rather use a metal dowel/tube you may need to use Locktite to keep it from slipping. That's where the fun ends, removing the metal dowel/tube is a great deal of fun since heating everything to at least 300 to soften the Locktite. Again, leave the dowel/tube in the chuck until you are done working. There is a third way if you have a piece of round stock long enough to go through the tube. The round stock has to be greater in diameter than the ID of the tube. Start by using a center drill on the end of the round stock to put your live end into to prevent wobble. Then turn the round stock down so you have a length longer than the tube and a slip fit. You then thread the end and use a washer and nut to secure the tube. The nut should tighten the tube against the shoulder where you turned down the round stock, not the chuck. Tightening against the chuck will ensure you pull the round stock out of the chuck when you tighten the nut. Again, leave the round stock in the chuck until the work is complete. Hex stock can also be used. BTW, you shouldn't use technical terms like "a scooch" in this group since it is obscure. I prefer "a tad." Dan, U.S. Air Force, retired |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why is Soaring declining | f.blair | Soaring | 266 | February 7th 09 12:58 PM |
Antique ex-freon now used as air compressor seen this type? | Jason D. | Home Built | 12 | November 17th 04 03:07 PM |
Non-Flying Ladders | Veeduber | Home Built | 5 | July 10th 04 05:15 AM |
Lathe Help | Bruce A. Frank | Home Built | 15 | February 7th 04 09:05 AM |