Worn Cobra rear-door hinges (both pin and hole)

I have a 2002 Cobra and the pins had worn through the sidewall of the
trailer before I had a chance to sleeve it. I will be forced to add
some sort of reinforcing plate to the trailer with the bush mounted to
that...
Not the best design for sure and I hope by now they will have fixed
it.

Bob 7U



On Dec 17, 4:24*pm, Dave Nadler wrote:
On Saturday, December 17, 2011 1:59:29 PM UTC-5, T8 wrote:
PS: ~55k miles on the trailer.

You should fly more and drive less :-).

8000 XC miles and 150 hours on my Antares this season.
Might even take it out tomorrow; amazingly Dr. Jack
says we'll have a wee bit of lift.

http://www.mcmaster.com/#bronze-sleeve-bearings/=fekwbm

Yep, Gotta check but I think: 6659K29

Anybody else seen this problem ?
Thanks in advance,
See ya, Dave "YO electric"

Hi Bob - You flying Sunday ? Dr. Jack says lift !
I may fly the Antares out of Fitchburg as its close
from my house and no one will be flying at Sterling.
Unlikely I'll make it up to Sugarbush with the short day.

Are your hinge pins worn as well as the channel ?

Best Regards, Dave "YO electric"