If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Lycoming O-235 dimensions question
Regarding the Lycoming O-235, O-290D and O-290D2... Lycoming says the engine is 29.06 inches long. But does that include the mags? Or just to the accessory case? Does someone have one handy that they might check on that? Appreciate it. -- Richard (remove the X to email) |
#2
|
|||
|
|||
Lycoming O-235 dimensions question
Just in case it helps, I just measured an O290D and found it near
exact 22" from the rear face of the mounting ears to the plane of the front face of the crankshaft flange. Sorry, no mags or accessories on it, so I can't help you with the original question. Thanks, Bob K. |
#3
|
|||
|
|||
Lycoming O-235 dimensions question
Richard, Check your mail inbox. Photos are in it of a 152 with a O235L2C with a tape measure showing the distances. I have more photos if needed. Best Regards, J. Severyn Livermore, Ca. |
#4
|
|||
|
|||
Lycoming O-235 dimensions question
John Severyn wrote:
Richard, Check your mail inbox. Photos are in it of a 152 with a O235L2C with a tape measure showing the distances. I have more photos if needed. Best Regards, J. Severyn Livermore, Ca. I got it, John. And replied. You covered the subject most throughly. Thanks so much. And thank you too, Bob. -- Richard (remove the X to email) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lycoming Prop-Strike AD question | Tien Dao | Piloting | 8 | November 28th 05 11:58 PM |
Dimensions NEEDED | jerry wass | Home Built | 14 | September 8th 05 12:56 AM |
Lycoming O-320 & Dynafocal Mount Dimensions | Ballchain | Home Built | 1 | October 21st 04 09:06 PM |
Lycoming -360 drawings and dimensions | Mr.Twistair | Home Built | 1 | November 1st 03 06:10 PM |
Lycoming -360 drawings and dimensions | Mr.Twistair | Rotorcraft | 1 | November 1st 03 06:10 PM |