If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
On 7/15/2005 11:17, Steven P. McNicoll wrote:
"Mark Hansen" wrote in message ... I'm an Instrument Airplane student, and am having a disagreement with my instructor on one topic - that of Aircraft Approach Categories. According to 14 CFR Part 97.3 (b), it provides the speed ranges for the different aircraft categories (A-E). In all the documentation I've read, this "speed" is the IAS of the airplane. However, my CFI says that this is based on the Ground Speed. When we are flying an approach with a tail wind and can see that, although we are remaining below 90kts IAS, our Ground Speed (shown by the GPS unit) is just over 90kts, he said I must use the category B minimums. I understand his reasoning (in that the faster we're moving across the ground, the faster we'll move out of the protection zone, etc.), but from what I can find, the FAR doesn't mention ground speed at all. If I use the minimums associated with the higher of the IAS or Ground Speed, would I get dinged during a proficiency check? The reason I ask is that I've been asked questions before where the examiner was trying to make sure that I completely understood the rule, and I'm worried that selecting minimums that are higher than necessary will show that I don't really understand it. I think your instructor is confusing the approach category speeds with the timing table speeds, which ARE ground speeds. No, Actually, he's not (unfortunately). -- Mark Hansen, PP-ASEL, Instrument Student Sacramento, CA |
#12
|
|||
|
|||
"Mark Hansen" wrote in message ... No, Actually, he's not (unfortunately). Well, he had to get the idea they were ground speeds somewhere. The timing table is pretty much the only possible source. |
#13
|
|||
|
|||
On 7/15/2005 11:52, Steven P. McNicoll wrote:
"Mark Hansen" wrote in message ... No, Actually, he's not (unfortunately). Well, he had to get the idea they were ground speeds somewhere. The timing table is pretty much the only possible source. His reasoning is that the faster we're moving across the ground, the faster we'll move outside of the protected area, for example, on the circling maneuver, and that to use the higher minimums 'just made good common sense'. However, he's interpreting the rule using this 'common sense' and claiming that this is what the rule implies. He made it clear to me that he was talking about the approach category minimums and not just the time from FAF to MAP (which, of course, is based on ground speed). -- Mark Hansen, PP-ASEL, Instrument Student Sacramento, CA |
#14
|
|||
|
|||
"Mark Hansen" wrote in message ... On 7/15/2005 11:12, Michael wrote: According to 14 CFR Part 97.3 (b), it provides the speed ranges for the different aircraft categories (A-E). In all the documentation I've read, this "speed" is the IAS of the airplane. And so it is (almost - I seem to recall it's really CAS, but that wouldn't make much difference). That's the regulation. However, my CFI says that this is based on the Ground Speed. It's hard to prove a negative, so I can't say there is NO regulatory support for what he says, but I've certainly never seen it. Have you asked him to show you where he read this? Further, without RNAV that works at low altitudes or DME on the approach (which isn't rare but is far from universal), ground speed is an estimate - and these rules are a lot older than widespread use of RNAV that works at low altitudes. In other words - I think your CFI is totally wrong on this one. The reason I ask is that I've been asked questions before where the examiner was trying to make sure that I completely understood the rule, and I'm worried that selecting minimums that are higher than necessary will show that I don't really understand it. Well, yes, it will. Only I think you understand it fine; it's your instructor who is steering you wrong. There are situations where it makes sense to select higher minimums on an approach (especially a circling approach) where the higher speed makes remaining within the protected area for the lower mins problematic. I certainly don't think it would be wrong to say "Yes, I know that technically cat A mins apply, but I am going to use Cat B mins because the wind conditions make remaining within the Cat A protected area problematic." If the situation is a circling approach with restrictions imposed and very high winds that would require an excessive bank angle to remain within the protected area, he would probably consider that a sign of good judgment. But you should be clear that this is something you are choosing to do because it makes sense, and that the regulations do permit lower mins. Thank you Michael. This is how I've been looking at it (but I didn't express it very well). When I've asked my CFI to show me the regs, he basically says that it makes sense to use the higher mins, and I haven't pushed it. This isn't the first time we've disagreed on the Regs. In another case, he claimed that it was illegal to fly IFR without a flight plan and ATC clearance, but that rule applies only to Controlled airspace. I think I won't bother pushing it, as I'm clear on the concept, and don't really need to head-but the CFI over it ;-) Michael -- Mark Hansen, PP-ASEL, Instrument Student Sacramento, CA I would fire him when it is convienent. There is no point in using a CFII that not only harbors errors in his understanding but is also incapable of learning and changing his position when it is pointed out to him. Of course, that applies to all people and all fields. Mike MU-2 |
#15
|
|||
|
|||
"Mark Hansen" wrote in message ... On 7/15/2005 11:52, Steven P. McNicoll wrote: "Mark Hansen" wrote in message ... No, Actually, he's not (unfortunately). Well, he had to get the idea they were ground speeds somewhere. The timing table is pretty much the only possible source. His reasoning is that the faster we're moving across the ground, the faster we'll move outside of the protected area, for example, on the circling maneuver, and that to use the higher minimums 'just made good common sense'. However, he's interpreting the rule using this 'common sense' and claiming that this is what the rule implies. He made it clear to me that he was talking about the approach category minimums and not just the time from FAF to MAP (which, of course, is based on ground speed). -- Mark Hansen, PP-ASEL, Instrument Student Sacramento, CA This CFII is stupid. Once you start circling the winds change and will become a headwind at some point. Mike MU-2 |
#16
|
|||
|
|||
On 7/15/2005 12:12, Mike Rapoport wrote:
"Mark Hansen" wrote in message ... On 7/15/2005 11:52, Steven P. McNicoll wrote: "Mark Hansen" wrote in message ... No, Actually, he's not (unfortunately). Well, he had to get the idea they were ground speeds somewhere. The timing table is pretty much the only possible source. His reasoning is that the faster we're moving across the ground, the faster we'll move outside of the protected area, for example, on the circling maneuver, and that to use the higher minimums 'just made good common sense'. However, he's interpreting the rule using this 'common sense' and claiming that this is what the rule implies. He made it clear to me that he was talking about the approach category minimums and not just the time from FAF to MAP (which, of course, is based on ground speed). -- Mark Hansen, PP-ASEL, Instrument Student Sacramento, CA This CFII is stupid. Once you start circling the winds change and will become a headwind at some point. Ya know ... I mentioned this to him as well. However, I think he's stuck on the Ground Speed reported by the GPS during the final approach as being the speed used to determine the approach category... That's just not what the FARs say. Mike MU-2 -- Mark Hansen, PP-ASEL, Instrument Student Sacramento, CA |
#17
|
|||
|
|||
Roy Smith wrote: In article , wrote: You are correct. There is no end to what some flight instructors will dream up or invent. Everything the FAA does in the world of charting is predicated on IAS. The one exception would be the FAF-MAP timing chart for non-precision approaches. That's groundspeed. Perhaps that's what got the instructor confused. The FAA doesn't provide timing tables in the source. The chart makers do those. Those are still indicated airspeed. If you choose to convert those values to TAS, then to G/S, that is your option and is a good operating practice. But, it is not mandatory, at least not in the sense that courses and altitudes on an IAP chart are mandatory. |
#18
|
|||
|
|||
"Steven P. McNicoll" wrote: wrote in message ... You are correct. There is no end to what some flight instructors will dream up or invent. Everything the FAA does in the world of charting is predicated on IAS. Not quite everything. The approach timing table uses ground speed. More correctly, the Jeppesen timing table states ground speed. NACO does not. |
#19
|
|||
|
|||
"Mark Hansen" wrote in message
... When I've asked my CFI to show me the regs, he basically says that it makes sense to use the higher mins, and I haven't pushed it. But using ground speed instead of airspeed could result in selecting lower mins rather than higher. --Gary |
#20
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NTSB: USAF included? | Larry Dighera | Piloting | 10 | September 11th 05 10:33 AM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 2nd 03 03:07 AM |
USAF = US Amphetamine Fools | RT | Military Aviation | 104 | September 25th 03 03:17 PM |
Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 05:12 AM |
Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 04:50 PM |