If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#8
|
|||
|
|||
Correct adhesive to use to attach tail wheel assembly.
On Sunday, April 1, 2018 at 10:19:49 AM UTC-5, Dan Marotta wrote:
Weldwood - me, too.Â* On my ASW-19b and LS-6a.Â* Works like a charm. Apply with a brush, allow to dry, then bring the parts together.Â* Be careful with alignment because it sticks! On 3/31/2018 8:01 PM, Tony wrote: On my Cirrus I've used Wildwood Contact Cement which comes in a can at Ace Hardware and others. So far so good -- Dan, 5J Thanks to all for the replies. Whine, be helpless and the soaring community responds. A buddy left some weldwood and a couple of brushes in my hangar. Thanks Jim. I am currently out of dry Italian Red wine. If you have any suggestions, please deliver to my hangar. 9P |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASW 19 tail wheel | [email protected] | Soaring | 13 | September 20th 16 11:09 PM |
spare tail dolly wheel assembly | [email protected] | Soaring | 3 | February 19th 15 02:29 PM |
ASW tail wheel | Dan Mockler | Soaring | 8 | July 31st 12 05:26 PM |
ASW tail wheel | Dan Mockler | Soaring | 0 | July 28th 12 09:53 PM |
FS: Blanik L-13 Tail Skid & Tail Wheel Assembly | Tim Hanke | Soaring | 0 | February 8th 05 01:34 PM |