If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Instrument Hole Punch
Has anyone used one of those combination punches (driven by a hand
wrench) that will make a 3.5 or 2.25 inch instrument hole in sheet metal? How thick an aluminum panel will it go through? Were you happy with the result? I'm thinking of fabricating a replacement instrument panel and want it to look good. |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
I used one to make my instrument panel and it worked great.
wrote in message oups.com... Has anyone used one of those combination punches (driven by a hand wrench) that will make a 3.5 or 2.25 inch instrument hole in sheet metal? How thick an aluminum panel will it go through? Were you happy with the result? I'm thinking of fabricating a replacement instrument panel and want it to look good. |
#4
|
|||
|
|||
Instaed of a hand wrench, use an impact wrench.
wrote in message oups.com... Has anyone used one of those combination punches (driven by a hand wrench) that will make a 3.5 or 2.25 inch instrument hole in sheet metal? How thick an aluminum panel will it go through? Were you happy with the result? I'm thinking of fabricating a replacement instrument panel and want it to look good. |
#5
|
|||
|
|||
wrote in message oups.com... Has anyone used one of those combination punches (driven by a hand wrench) that will make a 3.5 or 2.25 inch instrument hole in sheet metal? How thick an aluminum panel will it go through? Were you happy with the result? I'm thinking of fabricating a replacement instrument panel and want it to look good. They will make a clean hole in any aluminum you are likely to use in a panel. I have punched 1/8" steel, no problem. -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Instrument panel labelling options | John Galban | Home Built | 12 | November 18th 04 10:42 PM |
Instrument mounting question | Rob Turk | Home Built | 4 | July 19th 04 10:33 PM |
Cleaning up a reamed hole? | Boelkowj | Home Built | 5 | March 25th 04 01:32 AM |
Aluminum instrument panel finish? | Richard Riley | Home Built | 31 | February 4th 04 02:09 AM |
CAD outline of Rans S6S instrument panel? | Rob Turk | Home Built | 2 | October 21st 03 09:27 PM |