If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#41
|
|||
|
|||
"Must Have" Tools for Christmas
"Montblack" wrote I had one of those as a kid in the early 70's. It had a home out in the garage. ...we called it a rock tumbler. Might be a good idea to hold the plywood down, here and there! g I too, had a rock tumbler. Takes way too long. I seem to remember putting a bigger motor on it, or changing the drive ratio, to speed it up a "little" bit. I had to put the right kind of rocks in it, or they could start a fire! ;-)) -- Jim in NC |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Camloc Installation Tools | jls | Home Built | 13 | May 7th 04 05:11 AM |
EAA Chapte Tools | [email protected] | Home Built | 7 | March 8th 04 10:51 PM |
Why do you buy Snap-on tools? | Anonymo421 | Home Built | 12 | November 9th 03 09:40 AM |