If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
In article ,
Tony wrote: The throttle was real stiff and my dad just wants to change it out. We have an A&P to do work on the plane (he does lots of comanches)for flying time and he said its no problem to change it, it take about 2 hours Mine was also stiff when I got it, and about a week after I replaced it there was a cold snap and the mixture siezed up on me. If that's at all stiff you might as well replace it while you're in there. -- Ben Jackson http://www.ben.com/ |
#12
|
|||
|
|||
Hmmmm, I have 1000's of hrs in 250's and fly out of Montana and Wyoming. NEVER
once have I EVER picked up carb ice. Ever. I have never had to pull carb heat on landing EVER! The 540 manual says don't pull carb heat unless you get carb ice! (I thought that was why they ran the intake through the oil pan)? In over 10 years of flying 250's I have never pulled carb heat. except on every run up. When I fly my 206 I pull carb heat for landing all the time. Hmmm, that's what the Cessna book says to do. Maybe I just got a good 540. But I know may of my 250 friends that must have gotten good ones too, as they have never, ever had carb ice problems. Ae |
#13
|
|||
|
|||
*****The throttle was real stiff and my dad just wants to change it out. We
have an A&P to do work on the plane (he does lots of comanches)for flying time and he said its no problem to change it, it take about 2 hours******* Buy what FAA approved authorization will the "mechanic?" use to change the engine control system? He sounds like an idiot to me. Is there a STC for this? Are you planning to get a field approval for this unauthorized modification? You can't just "willy nilly" change critical control systems on aircraft certified in the "normal" category without FAA approval. I doubt if they would give such approval without an STC. If it is stiff when cold, why doesn't your "mechanic?" just fix it properly? Karl |
#14
|
|||
|
|||
"karl" wrote in message ... ] Buy what FAA approved authorization will the "mechanic?" use to change the engine control system? He sounds like an idiot to me. Is there a STC for this? Are you planning to get a field approval for this unauthorized modification? What on earth are you talking about. It's just a piece of control cable. You order another one. Chances are this one is gummed up dirt or someone kinked it somewhere with some hamfisted maintenance. You don't need STC's to replace parts. |
#15
|
|||
|
|||
*****What on earth are you talking about*****
He is changing a throttle cable from push-pull to vernier. What are you talking about, Ron? Karl |
#16
|
|||
|
|||
"karl" wrote in message ... *****What on earth are you talking about***** He is changing a throttle cable from push-pull to vernier. What are you talking about, Ron? OK, I missed that, but still hardly a major modification. |
#17
|
|||
|
|||
****OK, I missed that, but still hardly a major modification*****
Dream on Ron. Changing the system by which the engine is controlled is at least, very least, a major modification. There are numerous failure scenarios I can think of. Karl |
#18
|
|||
|
|||
"karl" wrote in message ... ****OK, I missed that, but still hardly a major modification***** Dream on Ron. Changing the system by which the engine is controlled is at least, very least, a major modification. There are numerous failure scenarios I can think of. "The system" is just a push-pull cable. Crikes, sticking a vernier twister on the panel end is not a major change in the design. You want to go get a 337 before you put fuel in the plane, that's fine by me, but it's not required. |
#19
|
|||
|
|||
Tony wrote in message ...
The throttle was real stiff and my dad just wants to change it out. We have an A&P to do work on the plane (he does lots of comanches)for flying time and he said its no problem to change it, it take about 2 hours I purchase a Comanche 260B, 1966 model, in 1993. Did an initial $10K annual on it during which I replaced all three engine controls with new venier controls. I move the controls to be in the correct order (throttle, prop, mixture) and selected new controls with correct shape and color coding. I never flew the airplane prior to that so I was never "confused" :-). I had the change field approved, form 337. I think the controls were from ACS, maybe purchased from Webco (you'll want to know those guys). The tail number was N9059P, so you can find the 337 in the FAA registry somewhere if you want to do the same thing. As to a venier throttle, I've got 1500 hours with one now (Comanche 260B, then T210L). I'd say you get used to it either way. I like being able to give a slight twist to add or take an inch of manifold pressure. I'm used to grasping it in such a way as to push in the release. I do that for landings or in prep for go around. The Comanche is a sweet airplane. Nice control feel, good performance (out flys my T210L by a noticeable margin unless I'm way up high). Can be tricky to land smoothly! -- Mike Ciholas (812) 476-2721 x101 CIHOLAS Enterprises (812) 476-2881 fax 255 S. Garvin St, Suite B Evansville, IN 47713 http://www.ciholas.com |
#20
|
|||
|
|||
Newps wrote:
Vernier throttle? What the hell would you want one of those for if you don't have a turbo? To do away with all the loosening and retightening of the damned locknut on the prehistoric factory throttle, for one reason. Another reason is to match the throttle to the already existing vernier prop and mixture controls. Need more reasons? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
For Keith Willshaw... | robert arndt | Military Aviation | 253 | July 6th 04 05:18 AM |
FS: 2002 "Ghosts: A Time Remembered" (Aviation) Calendar | J.R. Sinclair | Aviation Marketplace | 0 | June 14th 04 06:22 AM |
FS: 1990 Cracker Jack "War Time Airplanes" Minis 6-Card (CJR-3) Set | J.R. Sinclair | Aviation Marketplace | 0 | April 12th 04 05:57 AM |
Commanche alternatives? | Kevin Brooks | Naval Aviation | 23 | March 24th 04 03:22 AM |
Time Building Multi Engine | Midway Aviators | Aviation Marketplace | 0 | March 9th 04 04:57 AM |