|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 31st 03, 11:37 PM
|
|||
|
|||
Sticking Starter
The starter on my O-360 is not releasing when I let go of the starter
button. If I rev the engine slightly, it disengages at about 1500 RPM's. I have sprayed silicone spray on the ring gear, and well as the bendix of the starter but have only started it once since and it still stuck. Is this common? Is there a common fix? Has anyone had one apart? I'd like to know if the engine spinning faster causes it to disengage, or if it's only a a spring loaded bendix alone. Any help would be appreciated. Wayne 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C-150 (O-200) Starter | Dave | Home Built | 0 | November 25th 04 10:57 AM |
| Starter books? | Brad Mallard | Home Built | 5 | November 2nd 04 11:11 PM |
| Free Starter, Seattle Area... | John Ammeter | Home Built | 0 | October 31st 04 11:37 PM |
| Stuck starter solenoid? | Paul Lee | Home Built | 4 | April 16th 04 02:58 PM |
| WTB: Starter Clutch Assy for GO-300 (Manual Start) | Bob Romanko | Aviation Marketplace | 0 | November 11th 03 07:37 PM |
Threaded Mode