If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
On Thu, 14 Aug 2003 09:58:05 -0400, "Ron Natalie"
wrote: snip Underseat or Baggage compartment? These were factory mods and are on the original single engine type certificate. Underseat. He tried to explain it to the Federales in that manner, but the install wasn't documented anywhere. I think the whole Camair thing had them flustered from the get-go. I worked a couple nagging gripes on the "demo" Rangemaster a few years back. The really funny one was varying/high idle speed. Don't understand that. Should be a rather straight forward IO-520 installation. Nope, this sucker (the "demo" ship) had been modified numerous times in varying manners. I only worked on it a couple times, don't know all the details. It had a Piper single throttle quadrant installed, but the gear/throttle warning switch was mounted near the carburetor (instead of in the quadrant Piper-style). Carburator? What the hell did they use for an engine in these things. No Rangemaster ever had a carburator. They also never had throttle quadrants. Only the twins had those. OK, so it might have been an up-draft injector unit. It's been too long, I can't say for sure that it had a Continental engine. It definitely had been fitted with an retract Piper single quadrant. I popped the cover off of it and showed the "marketing consultant" that was flying the 'plane the holes where Piper mounted the throttle/gear warning switch, even gave the guy the p/n for the proper switch. This airplane was far from a "stock" configuration. snip Only other thing I remember was the owner squealing like a pig when I told him I wanted to replace the diaphram in his prop (was older than I was at the time). He was extremely lucky. I never got more than a couple of years out of the diaphram at a time. I think Hartzell only claims they're good for 3 years anyhow. Got the drill down, pull the spinner, unhook the actuator linkage, remove the pin, unscrew the big nut, pull the prop. Unscrew the retainers for the diaphram, replace, resafety wire all those dang screws and put the prop back on... I can dig it. When I figured out how long that thing had been in there, it scared the crap out of me. Didn't fly it 'til after the inspection/diaphram replacement (was "out" of annual when I yanked it out of the hangar). I really enjoyed flying it. The radios were ancient, but everything was "there", it met the Federal requirements for an annual inspection (barely)- was in dire need of some TLC. TC |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
molding plexiglas websites? | [email protected] | Owning | 44 | February 17th 05 09:33 PM |
Cleveland Parking Brake Parts | Jeff | Home Built | 2 | October 11th 04 10:38 PM |
Question on Owner Produced Interior parts | NW_PILOT | Owning | 15 | July 16th 04 05:40 AM |
Navion Parts Availability | Margy Natalie | Owning | 12 | August 15th 03 03:47 AM |
The urban legend of the buried spitfire parts | MBannister | Military Aviation | 1 | July 28th 03 01:15 AM |