If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
I once had an instructor that gave me a little trick to use when
landing, as I had the same tendency as you to want to raise collective. Even when I didn't raise it seemed I would just float at about 1 to 2 feet above the ground. So he tells me to just put in small cyclic or pedal movements(not even enough to notice an attitude or heading change) basically just wiggling the cyclic or wiggling your feet slightly back and forth on the pedals. It takes enough power away from the main rotor to put you in a gentle descent without needing to lower collective at that close to the ground. My problem was that when I stopped descending at 1 or 2 feet i would lower collective to get down, and still being ham handed on the controls as this was early in my training I would inevitably wind up with a hard landing. Talk to your instructor before trying this as he/she may not recommend the gyrating of the controls at this stage in your training! Having said that, it does work and gives your hands/feet something to do rather than raising that collective. Get yourself in the air, no matter how you get up there! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Most reliable homebuilt helicopter? | tom pettit | Home Built | 35 | September 29th 05 02:24 PM |
First 2 1/2 hours PPL(H) today! | Simon Robbins | Rotorcraft | 42 | September 25th 05 12:54 AM |
Mini-500 Accident Analysis | Dennis Fetters | Rotorcraft | 16 | September 3rd 05 11:35 AM |
millionaire on the Internet... in weeks! | Malcolm Austin | Soaring | 0 | November 5th 04 11:14 PM |
"I Want To FLY!"-(Youth) My store to raise funds for flying lessons | Curtl33 | General Aviation | 7 | January 9th 04 11:35 PM |