|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
December 8th 03, 04:25 PM
|
|||
|
|||
"David O" wrote in message
... "Rich S." wrote: How does one tell the difference? Rich "The Emeraude has an ex-Cherokee 140 E3D" S. Serial numbers for Lycoming wide-deck engines end with an "A" while serial numbers for Lycoming narrow-deck engines do not end with an "A". Narrow-deck cylinders are held down with internal-hex nuts (driven by a hex wrench) and sometimes, but not always, have hold-down plates. Wide-deck cylinders are held down by common-looking hex nuts and do not use hold-down plates. Thanks! Rich S. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| V-8 powered Seabee | Corky Scott | Home Built | 212 | October 2nd 04 11:45 PM |
| 0-235 lyc cylinders needed (3) | Captain Dave | Home Built | 0 | October 8th 03 08:00 PM |
Threaded Mode