If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
Ernest Christley wrote in message r.com...
Corrie wrote: Ernie, what's the Delta stressed for? I perused your site, but didn't see an illustration of the spar attach fittings. A half-inch pin sounds right. But what kind of fitting does it go through, and how is that fitting tied into the spar? That's the real question. Normal category. 1950lbs gross. I just put a couple pictures and and explanation at the bottom of the 'Frame' section of my website. Follow the link below. Tell your lovely wife 'thank' for helping out. I'm afraid it's still not entirely clear, but it looks like the whole structure hangs on those two 1/4" fittings welded to the spar truss, inserted into the vertical hinge tube, and held in place by the 1/2" pin? Make certain those are solid welds, my friend! |
Thread Tools | |
Display Modes | |
|
|