![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
On Friday, February 3, 1995 at 4:26:02 PM UTC-5, wohlsen wrote:
Thank you to all who responded to my previous query concerning foam core construction. I have heard that common epoxies used in composite construction do not adhere to plastic films such as Saran wrap. Is this correct? If so is it feasible to employ it as a release agent when building a thin wall, non-structural component such as a cowling? That is, can I wrap a male plug made of styrofoam with Saran wrap, lay on the epoxy and glass, smooth and fill to desired finish, and then pull out the plug and add any internal bracing necessary to maintain its shape? Thanks for any comments. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
vinyl wrap | [email protected] | Soaring | 14 | October 8th 18 05:55 PM |
Uvalde wrap-up | DRN | Soaring | 9 | August 21st 08 01:27 PM |
Tie Wrap on Ventus Fin??? | Gary Emerson | Soaring | 5 | March 30th 08 08:18 PM |
Question about epoxy resin chemistry.. | Chris | Home Built | 26 | April 15th 04 12:55 AM |
question: differences between epoxy layup and plaster | Morgans | Home Built | 3 | August 6th 03 04:46 AM |