|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 4th 04, 11:27 PM
|
|||
|
|||
Hydraulic Motion Platform saotware and hardware
Well I posted a message a week ago for anyone knowing about the
sims I purchased from Fightertown and only received one response so I guess I am going to start from scratch on these units. What i have is 9 sim pods and one Stealth bomber sim. All of the units have hydraulic motion platforms. Since i do not have knowledge about either the software or hardware that is needed to get these operational I plan to start with the Stealth first to get my feet wet. I have been doing a lot of reading on websites and newsgroups but there is not much on getting sims like these working. If there is anyone reading this who has had any experience with hydraulic motion platforms and the software to run them I would appreciate hearing from you. If you want to see the sims you can visit my page at www.flightsimulators.net Thanks, Rich 
|
|
#2
November 13th 04, 01:28 AM
|
|||
|
|||
|
Where are you and the simulators located?
|
|
#3
November 13th 04, 01:28 AM
|
|||
|
|||
|
Where are you and the simulators located?
|
|
#4
November 13th 04, 01:28 AM
|
|||
|
|||
|
Where are you and the simulators located?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
