|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 4th 08, 01:32 AM
|
|||
|
|||
mode c intermittent
Howdy,
I have an Aeromech 8140B20 encoding altimeter with a KT76 transponder. Mode C is intermittent with ATC. Is it more than likely this is an altimeter problem or transponder problem? Sometimes when it is not reporting, i cycle the transponder off then back on and it starts reporting again. Thanks in advance, Brian Also, sould an aeromech and aerosonic encoding transponder interchange as far as the connections are concerned? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intermittent failures all weekend | Ron Natalie | Piloting | 5 | March 25th 07 05:25 PM |
| Air Force investigating intermittent engine failure on aircraft. | SPLASH-TWO | Aviation Photos | 25 | November 23rd 06 06:34 PM |
| New transponder mode S vs. mode C | Tom N. | Soaring | 39 | November 7th 06 07:40 AM |
| C182 - Intermittent Alternator | WinstonCup | Owning | 9 | November 12th 04 12:22 AM |
| Mode S to become requirement? | Bob Chilcoat | Owning | 6 | July 14th 04 11:25 PM |
Linear Mode
