|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 3rd 05, 06:37 AM
|
|||
|
|||
E-185-225 Cont.
Does anyone have a drawing showing the layout of the cylinder base
hold-down bolts/studsof the old Continental E-185-225 series ??.. Is it a bolt circle with degree spacing , or rectangular measurements taken from some reference point ??--( I need to shim my jugs out a tad.) Thanks in Advance Jerry 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cont A40 Prop wanted | Larry | Aviation Marketplace | 3 | November 13th 04 12:19 AM |
| Warp Drive 2-blade HP hub for Cont. | Shawn | Aviation Marketplace | 0 | September 9th 04 07:50 AM |
| Detonation in a Cont. 550 | [email protected] | Home Built | 3 | August 28th 04 05:33 AM |
| Detonation in a Cont. 550 | Corky Scott | Piloting | 2 | August 28th 04 05:33 AM |
| Detonation in a Cont. 550 | [email protected] | Piloting | 0 | August 26th 04 01:45 PM |
Hybrid Mode
