A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Home Built Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
May 2005 KitPlanes Article Question by Larry
I am trying to build your project from the May 2005 KitPlanes. Need to know what the value for R107 as it is not on the schematic. Many Thanks, Larry
July 9th 05 02:56 PM
by RST Engineering Go to last post
1 825
Continental accessory case by pwm
Does anyone know if a Continental O-200 or a C-75 rear accessory case will fit an A-65? Reason for asking is that I'm wanting to add a starter and a generator. Thanks, Monty
July 9th 05 02:27 AM
by Cy Galley Go to last post
3 620
About Finished by [email protected]
Buy this great 172G so I can roll the money over into another project. I have been working on it for a dam* year and a half. Keeps me out of flame wars. You should see the powder-coated control wheels, what flashy little darlins they are. Better description in rec.aviation.marketplace. Pride of...
July 8th 05 08:59 PM
by wmbjk Go to last post
8 549
Oshkosh camping by keepitrunning
Last time I was there I parked my airplane in the homebuilt parking and camped next to it. I am wondering if a friend flew in with me in a production aircraft, could we park together in the homebuilt parking or would they have to go off with the production parking. Can you camp in the production...
July 8th 05 05:55 AM
by Morgans Go to last post
50 2,522
Oshkosh gate admission on Sunday 24th? by Montblack
I've not been to Oshkosh on the first weekend, always later in the week. Can you walk around looking at planes (for free) on Saturday 23rd and Sunday 24th? Show opens on Monday, July 25th. When do they start charging 'gate admission' at Oshkosh? What's open/available the first weekend vs. what's...
July 7th 05 11:56 PM
by jsbougher Go to last post
83 3,306
missing log entry by OtisWinslow
I'm looking at an older Kit Fox and when I went through the log book there's no entry that the Phase One testing was completed and yet the plane has been flying for the last few years and has a couple hundred hours on it. They have no idea how to get hold of the original builder. Has anyone dealt...
July 7th 05 10:23 PM
by Gig 601XL Builder Go to last post
3 515
Panel Planning website by Gig 601XL Builder
There is a very basic FREE panel planning website out there somewhere. I used it before but can't fot the life of me remember what the URL was. I've Googled both the web and this group and can't find it. Anybody know it off hand? GigG
July 7th 05 07:22 PM
by Gig 601XL Builder Go to last post
2 499
ICOM A24 by John Sp
Can anyone tell me if this radio can be operated and re-charged (at the same time) from a 12V source -(Aircraft/Auto battery) Thnaks in advance from John in Cape Town
July 7th 05 11:59 AM
by Scott Go to last post
4 990
Unusual ECI Cylinder by [email protected]
So I'm doing dry clearance on the lifters and one pushrod is jammed up tight against the toe of the rocker arm, even with the lifter collapsed. Says the A&P/IA, "You didn't collapse the lifter." "Oh, but yes, I did." "How?"
July 7th 05 01:27 AM
by Jerry Springer Go to last post
4 969
Don's Dream Machines Fly-In Forum by Deborah McFarland
Fly-In Forum: Don Swords and the staff of Don's Dream Machines will be at Pickens County Airport, Jasper, Ga (JZP), from 9:00 am to 3:00 pm to answer questions about engine overhaul and repair, aircraft certification, homebuilding and avionics. Don is a well respected and knowledgeable IA, DAR, and...
July 6th 05 10:22 PM
by W P Dixon Go to last post
4 572
Aircraft Books by David R Townend
AeroFile now has two titles available. Military Aircraft Designations and Systems United States Navy Hull Numbers. Inventories are getting low so please act now Please log onto to www.aerofile.ca and www.aerofile.ca/usn for more information
July 6th 05 05:54 PM
by David R Townend Go to last post
0 824
Engine running again, the good, bad and ugly by Corky Scott
I finally got my Ford V-6 going again after partially dismantling it to repair a cracked timing chain cover. As I mentioned previously, I'd noticed the crack in the timing chain cover the first time I assembled the engine, but "repaired" it that time using some metalized epoxy that was...
July 6th 05 05:04 PM
by Blueskies Go to last post
34 2,580
Dinged Up Prop by [email protected]
A friend with an RV-6 and one of those beautiful wooden props dinged it up with a rock or some kind of FOD. The damage left a half-inch notch about 15 inches inboard of the tip, so he filled it with epoxy and went on like nothing happened. One day he was at altitude over Rutherfordton playing...
July 6th 05 04:42 AM
by Roger Go to last post
3 499
Cottage available for 2005 EAA Oshkosh by [email protected]
We have a year round 2 Bedroom Cottage located on a quiet lake 50 miles west of Oshkosh in Waushara county. Rent is $125/night or $700/week. e-mail if you are interested.
July 5th 05 04:23 PM
by [email protected] Go to last post
0 575
Sparkplug torque values by Roger
I've spent the better part of an hour and a half on the net searching, tried to get into the ABS site which appeared to be down, spend several hours searching through what manuals I have, but I couldn't find the torque required for the spark plugs in an IO-470N. I did find the torque values for...
July 5th 05 03:40 AM
by Roger Go to last post
12 1,319
Control surface alignment by [email protected]
I'm hoping the home built community can assist me with a small problem. I own a glider that does not fly straight without applying a little constant cross control (L stick and R rudder). If hands are removed from the controls, it slips (or yaws?) to the left, and then the nose gently swings around...
July 4th 05 10:06 PM
by Darrel Toepfer Go to last post
10 1,280
Bose Headset for SALE! by Tom Enterline
Bose Headset for SALE! Bose Aviation Headset Series I Panel Mount Great Condition $150 This headset cost $1000 new! Panel Mount Kit for Bose Headset New kit! still in the box $30
July 4th 05 09:45 PM
by Tom Enterline Go to last post
0 940
Lightweight Starter for Sale! by Tom Enterline
This starter is for a Grumman Traveler or Cheetah with the Lycoming O-320 E2G. Electrosystems Part # MZ-6222 At 7 1/2 lbs., MagnaFlite is the lightest starter on the market. It weighs 60% less than conventional starters, and is the easiest to install with absolutely no modifications required....
July 4th 05 09:25 PM
by Tom Enterline Go to last post
0 1,074
Starting a Super Cub Rebuild by [email protected]
Anybody know of fuselage jigs in the Western North Carolina area or vicinity? Also, this aircraft had an O-235 engine with 105 HP. I'm considering using an O-320A with 150 HP, which weighs just 10 or 20 pounds more. Anybody got any advice pro or con about the engine change? TIA.
July 4th 05 06:11 PM
by [email protected] Go to last post
0 428
Oshkosh Bound Posters by RST Engineering
The 2005 Oshkosh Bound documents are up on the website for download. There are two zip files. One contains all the posters (camping, classic, homebuilt, camping, etc) and the other contains a clean graphic of the Ripon-Fisk-Oshkosh runway procedures. Comments and error-reporting appreciated. Jim
July 4th 05 03:03 AM
by Jay Honeck Go to last post
7 1,229
Post New Thread


Display Options
Showing threads 3501 to 3520 of 6903
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 04:51 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.